Setting Bass Frequency; Setting Visual Mode - Alpine CVA-1006 Owner's Manual

NOTES
• Immediately after inputting titles or changing the
settings of Setup Mode or Display Mode (While the
system is inputting the titles or data automatically) do
not turn the ignition key (engine key) to OFF.
Otherwise, the title may not be written, or the settings
may not be changed.
• When the voice guidance of the Navigation system
starts to interrupt the audio, the display is
automatically changed to the navigation screen.
• The volume level of the audio will be automatically
reduced when the voice guidance of the Navigation
system starts.

Setting Bass Frequency

1
Press the SOURCE button.
The main menu appears on the display.
2
Press the 6 (SETUP) button.
The Setup mode screen appears.
3
Rotate the rotary encoder and select "BASS
Cont." to activate the Bass Control mode.
4
Press the Function button 1 (60 Hz) through
4 (100 Hz) that has the frequency you wish to
control.
5
Press the FUNC (RETURN) button.
The display returns to the main menu screen.
NOTES
• Immediately after inputting titles or changing the settings
of Setup Mode or Display Mode (While the system is
inputting the titles or data automatically) do not turn the
ignition key (engine key) to OFF.
Otherwise, the title may not be written, or the settings may
not be changed.
• When an equalizer or digital sound processor is connected,
this function is inoperative.
• After carrying out the steps 1 to 3 of "To display the Setup
mode screen" described on page 40, perform the operation
show below.

Setting Visual Mode

For direct access to the different visual screens,
preset the Navigation or the V. SEL mode. You can
then display the screen of the preset item by just
pressing the V. SEL button on the IVA-C801/CVA-
1006.
NOTE
After carrying out the steps 1 to 3 of "To display the Setup
mode screen" described on page 40, perform the
operation show below.
1
Press the SOURCE button.
The main menu screen appears on the display.
2
Press the 6 (SETUP) button.
The Setup mode screen appears.
3
Rotate the rotary encoder and select "VISUAL."
The Function Guide is displayed.
4
Press the 1 (NAV.) or 2 (V. SEL) to preset the
desired item.
• When "NAVI" is preset: Pressing the V. SEL
button directly switches to the navigation
screen.
• When "V. SEL" is preset: Each press of the
V. SEL button switches the modes:
→ NAVI. → AUX1 → AUX2 → DISPLAY
NOTE
Immediately after inputting titles or changing the settings
of Setup Mode or Display Mode (While the system is
inputting the titles or data automatically) do not turn the
ignition key (engine key) to OFF.
Otherwise, the title may not be written, or the settings
may not be changed.
43
-EN