Auxiliary Device Operation (Optional); Operating Auxiliary Devices - Alpine CVA-1006 Owner's Manual

Auxiliary Device Operation (Optional)

(IVA-C801)

Operating Auxiliary Devices

To operate your devices connected to the AUX
terminals on the rear panel of IVA-C801/CVA-1006,
follow the procedure described below.
WARNING
It is dangerous (and illegal in many states) for the
driver to watch the TV/Video while driving the
vehicle. The driver may be distracted from looking
ahead and an accident could occur.
Install the IVA-C801/CVA-1006 correctly so that
the driver cannot watch TV/Video unless the
vehicle is stopped and the emergency brake is
applied.
If the IVA-C801/CVA-1006 is not installed
correctly, the driver will be able to watch the TV/
Video while driving the vehicle and may be
distracted from looking ahead causing an
accident. The driver or other people could be
severely injured.
To activate your auxiliary devices:
To watch a video source, your vehicle must be
parked with the ignition key in the ACC or ON
position. To do this, follow the procedure below.
1. Push the foot brake to bring your vehicle to a
complete stop at a safe location. Engage the
parking brake.
2. Keep pushing the foot brake and release the
parking brake once then engage it again.
3. While the parking brake is being engaged the
second time, release the foot brake.
NOTE
For automatic transmission vehicles, place the transmission
lever in the Park position.
26
-EN
SOURCE Rotary encoder
(CVA-1006)
Now, the locking system for the AUX mode operation
has been released. Unless the ignition key is turned
to the OFF position, the AUX mode can be activated
by engaging the parking brake without performing
the above procedure (1 through 3).
Each time the ignition key is turned to the OFF
position, perform the above procedure.
NOTE
If you try to activate the auxiliary device while driving, the
display will show the warning-CAN'T OPERATE WHILE
DRIVING.
1
Press the SOURCE button.
The main menu screen appears on the display.
2
Rotate the rotary encoder and select "AUX", then
press the rotary encoder to execute the
selection.
NOTE
If the AUX mode is not displayed on the main menu,
select "AUX IN" in the Setup mode screen. Either AUX1
or AUX2 should be turned ON.
SOURCE
Rotary encoder