Felker TM-75 Operating Instructions And Parts List Manual page 9

WARNING:
INSTRUCTIONS COULD RESULT IN DEATH OR SERIOUS BODILY INJURY.
DO NOT operate this machine unless you have read and understood this operator's manual.
operate this machine without the blade guard, or other protective guards in place.
DO NOT
stand behind or in front of the blade path while the motor is running.
DO NOT
DO NOT leave this machine unattended while the motor is running.
work on this machine while the motor is running.
DO NOT
DO NOT operate this machine when you are tired or fatigued.
use a wet blade without adequate water supply to the blade.
DO NOT
DO NOT exceed maximum blade speed shown for each blade size. Excessive speed could result in blade breakage.
operate the machine if you are uncertain of how to run the machine.
DO NOT
use damaged equipment or blades.
DO NOT
DO NOT touch or try to stop a moving blade with your hand.
cock, jam, wedge or twist the blade in a cut.
DO NOT
DO NOT use a blade that has been dropped or damaged.
use carbide tipped blades.
DO NOT
DO NOT use abrasive blades.
touch a dry cutting diamond blade immediately after use. These blades require several minutes to cool
DO NOT
after each cut.
use damaged or worn blade flanges.
DO NOT
DO NOT allow other persons to be near the machine when starting or when the machine is in operation.
operate this machine in an enclosed area unless it is properly vented.
DO NOT
DO NOT operate this machine in the vicinity of anything that is flammable.
explosion.
allow blade exposure from the guard to be more than 180 degrees.
DO NOT
operate this machine with the blade guard removed.
DO NOT
DO NOT operate this machine unless you are specifically trained to do so.
use a blade that has been over heated (Core has a bluish color).
DO NOT
DO NOT jam material into the blade.
grind on the side of the blade.
DO NOT
DO NOT lay power cords in or near the water.
replace the motor with any motor that does not have a special grounding connection.
DO NOT
stand or lean on machine.
DO NOT
DO NOT start cutting with a saw until you have a clear work area and secure footing.
operate this machine while using drugs or alcohol.
DO NOT
This saw was designed for certain applications only. DO NOT modify this saw or use for any application
other than for which it was designed. If you have any questions relative to its application, DO NOT use the
saw until you have written Electrolux Construction Products and we have advised you.
SAFETY FIRST!
DO'S AND DO NOTS
FAILURE TO COMPLY WITH THESE WARNINGS AND OPERATING
WARNINGS
DO NOT
*****************
Sparks could cause a fire or an
Electrolux Construction Products
17400 West 119th Street
Olathe, Kansas 66061
1-800-365-4003
9