Advertisement
Quick Links
™
B323
1
2
Using a small flat
Insert the 23A battery
screwdriver, insert into the
(supplied) into the battery
locking clip and gently
holder, making sure the
twist. The back plate will
Positive/Negative terminals
unclip from the Bell Push.
match the internal
markings. Battery Comes
Preinstalled
4
5
ON
Press the learn button (L)
Press the Bell Push within
on the front of the Chime
30 seconds, the Chime
to enter the Learn mode.
will ring to confirm that
The chime will ring to
the Bell Push has been
confirm.
paired to the Chime.
Tel: 0845 2301231
9-5 Mon-Fri, Local call charges apply
For help and support visit:
www.chbyron.com
50Metres
Wire Free Plug-through
Chime
3
Insert the Plug-in Chime into a
standard 220-240V ~50Hz wall
socket and switch the socket ON,
Chime will ring.
6
ON
Test the Chime in the intended
location, as internal walls and
surfaces may reduce operating
range. DO NOT mount onto
metallic surfaces.
Plug in a standard plug
e.g. Table light.
Max load: 1000W
CH Byron
(UK)
Byron House, Sherwood Rd
Astonfields, Bromsgrove
B60 3DR
UK
Usage Guide:
Avoid positioning the Bell Push/Chime on or directly near
metallic surfaces as this may reduce the operation range.
UPVC Door Frames:
When positioning the bell push onto a UPVC door, always check the
operating performance before final installation, internal metal frame of
the door may affect performance.
Tip: Try adjusting the location of the Bell Push slightly to the Left/Right or place on
external wall.
Note: the appliance is not to be used by children or persons with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge,unless they have
been given supervision or instruction. Children should be supervised to ensure that
ON
they do not play with the appliance.
Melody
Selection:
ON
To select a new melody for the Door Chime
1:Press the Melody Select button on the
front of the Chime unit (M).
2:The Chime will play the newly selected
melody.
3:Press again to select the next melody.
Specification
Bell Push: DBT-SL
Power: 1 x 23A 12V DC Battery (supplied)
IP44 Weather Resistant
Bell Push & Door Chime:
1: Using back plate as template
2: Making sure UP arrow points UP.
3: Mark and drill holes.
4: Insert wall plugs and attach to wall using screws
provided.
5: Clip the Bell Push on to the back plate making sure
Bell Push 'Clicks' into place.
6: Place the Door Chime within the operating range (50M).
Transmission of the wire free signal through Walls, Doors
and Ceilings etc, may reduce the operating range.
The Chime is designed for INDOOR use only.
Resetting
Chime:
ON
To reset the chime and delete the bell push
learnt to the chime
1:Press and hold the Learn button (L) until
the Chime plays a melody - approximately
6 seconds.
2:The Chime has been reset
- see Points 4 & 5 to pair Bell Push
Plug-ithrough Door Chime: B306
Power: 240 - 250V 50Hz
Range: 50 Metres
Max Load: 1000W
Indoor Use Only
APPROVED
ON
Project Manager:Mr G Hunter
R&TTE
V1.0
Advertisement
