Broan ALLURE QSE1 SERIES User Manual
Broan ALLURE QSE1 SERIES User Manual

Broan ALLURE QSE1 SERIES User Manual

Hide thumbs Also See for ALLURE QSE1 SERIES:

Advertisement

Available languages

Available languages

ALLURE
®
QSE1 SERIES
RANGE HOODS
READ AND SAVE THESE INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY
TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer. If
you have questions, contact the manufacturer at the address or
telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service panel
and lock the service disconnecting means to prevent power from
being switched on accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by a qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction codes and standards.
4. Sufficient air is needed for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment to
prevent backdrafting. Follow the heating equipment manufacturer's
guideline and safety standards such as those published by the
National Fire Protection Association (NFPA), and the American
Society of Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
5. When cutting or drilling into wall or ceiling, do not damage electrical
wiring and other hidden utilities.
6. To reduce the risk of fire or electric shock, do not use this range
hood with an additional speed control device.
7. Ducted fans must always be vented to the outdoors.
8. To reduce the risk of fire, use only metal ductwork.
9. Use with approved cord-connection kit only.
10.This unit must be grounded.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
1. Never leave surface units unattended at high settings. Boilovers
cause smoking and greasy spillovers that may ignite. Heat oils
slowly on low or medium settings.
2. Always turn hood ON when cooking at high heat or when flambeing
food (i.e.: Crêpes Suzette, Cherries Jubilee, Peppercorn Beef
Flambé).
3. Clean ventilating fans frequently. Grease should not be allowed to
accumulate on fan or filter.
4. Use proper pan size. Always use cookware appropriate for the size
of the surface element.
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT
OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*
1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal
tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS.
If the flames do not go out immediately, EVACUATE AND CALL
THE FIRE DEPARTMENT.
2. NEVER PICK UP A FLAMING PAN — You may be burned.
3. DO NOT USE WATER, including wet dishcloths or towels - violent
steam explosion will result.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher and you already
know how to operate it.
B. The fire is small and contained in the area where it started.
C. The fire department is being called.
D. You can fight the fire with your back to an exit.
* Based on "Kitchen Fire Safety Tips" published by NFPA.
!
FOR DOMESTIC COOKING ONLY
!
CAUTION
1. For indoor use only.
2. For general ventilating use only. Do not use to exhaust hazardous
or explosive materials and vapors.
3. To avoid motor bearing damage and noisy and/or unbalanced impel-
lers, keep drywall spray, construction dust, etc. off power unit.
4. For best capture of cooking impurities, your range hood should be
mounted so that the top of the hood is 24-30" above the cooking
surface.
5. Please read specification label on product for further information
and requirements.
Installer: Leave this manual with
the homeowner.
Homeowner: Operating and
Cleaning information on page 5.
TABLE OF CONTENTS
This manual is divided into sections as follows:
PREPARE HOOD LOCATION
Run ductwork from roof or wall cap, and electrical wiring from
service panel - to installation location
PREPARE THE HOOD
Get your hood ready for installation
CONNECT WIRING
Make electrical wiring connections to hood
INSTALL HOOD
Secure hood to cabinet and ductwork - install bulbs and filters
OPERATION
How to use the hood controls
CLEANING
Keep your hood in top working condition
SERVICE PARTS
Part numbers and exploded view of hood components
WARRANTY
One-year limited warranty and how to contact us
Register your product online.
In the US at: www.broan.com
In Canada at: www.broan.ca
ALLURE
QSE1 SERIES
®
RANGE HOOD
Page 1
Patent No.:
US D450, 829 S
!

Advertisement

Table of Contents
loading

Summary of Contents for Broan ALLURE QSE1 SERIES

  • Page 1 OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:* CLEANING 1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal Keep your hood in top working condition tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. SERVICE PARTS If the flames do not go out immediately, EVACUATE AND CALL Part numbers and exploded view of hood components THE FIRE DEPARTMENT. 2. NEVER PICK UP A FLAMING PAN — You may be burned. WARRANTY 3. DO NOT USE WATER, including wet dishcloths or towels - violent One-year limited warranty and how to contact us steam explosion will result. 4. Use an extinguisher ONLY if: A. You know you have a Class ABC extinguisher and you already know how to operate it. Register your product online. B. The fire is small and contained in the area where it started. In the US at: www.broan.com C. The fire department is being called. In Canada at: www.broan.ca D. You can fight the fire with your back to an exit. * Based on “Kitchen Fire Safety Tips” published by NFPA.
  • Page 2: Prepare The Hood

    ALLURE QSE1 SERIES ® RANGE HOOD Page 2 PREPARE HOOD LOCATION 7” ROUND ROOF CAP VERTICAL DUCTING 3¼" X 10" or 7” ROUND (For vertical discharge) SOFFIT HOUSE WIRING CABINET (Top or Back of hood) WALL CAP HOOD HOOD 24" - 30" ABOVE 3¼"...
  • Page 3: Range Hood

    ALLURE QSE1 SERIES ® RANGE HOOD Page 3 PREPARE THE HOOD PREPARE THE HOOD TOP RECTANGULAR DUCT KNOCKOUT (Remove for 3¼” x 10” Vertical Discharge) DAMPER/DUCT CONNECTOR REAR RECTANGULAR DUCT KNOCKOUT (Remove for 3¼” x 10” Horizontal Discharge) Remove Damper/Duct Connector from inside the hood. Set connector aside - with mounting screws and parts Remove appropriate Duct Knockout(s) from top or back of bag.
  • Page 4: Connect Wiring

    ALLURE QSE1 SERIES ® RANGE HOOD Page 4 CONNECT WIRING INSTALL HOOD WARNING: To reduce the risk of electric shock, make sure power is switched off at the service panel. Lock or tag service panel to prevent power from being switched on accidentally. KEYHOLE MOUNTING GREEN...
  • Page 5: Lamp Replacement

    ALLURE QSE1 SERIES ® RANGE HOOD Page 5 OPERATION LAMP REPLACEMENT LIGHT LENS Fan: The 3-position rocker switch (on the left) controls the fan. The left position is low speed, center position is off, and right position is high speed. An indicator light shows that the fan is on. Light: The 3-position rocker switch (on the right) controls the lights. The left position is low light intensity, center position is off, and right position is high light intensity. CLEANING Pull Tab on Light Lens forward and pull down to remove lens.
  • Page 6: Service Parts

    THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. During this one-year period, Broan-NuTone will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.
  • Page 7 PIÈCES DE REMPLACEMENT ÉVACUEZ LES LIEUX ET APPELEZ LES POMPIERS. Liste des pièces de remplacement avec leur numéro d’identification 2. NE VOUS EMPAREZ JAMAIS D’UN PLAT QUI S’EST ENFLAMMÉ – Vous et schéma détaillé des composantes de la hotte. risqueriez de vous brûler. 3. N’UTILISEZ JAMAIS D’EAU, incluant les linges à vaisselles ou serviettes GARANTIE mouillés car cela peut provoquer une violente explosion de vapeur. Garantie limitée de un an et coordonnées pour communiquer avec 4. Utilisez un extincteur SEULEMENT si: notre service à la clientèle. A. Il s’agit d’un extincteur de classe ABC et que vous savez comment vous en servir. B. Il s’agit d’un petit feu qui ne se propage pas ailleurs que sur Enregistrez votre produit en ligne. la cuisinière. C. Les pompiers ont été avisés. Aux États-Unis à : www.broan.com D. Vous pouvez combattre le feu tout en ayant accès à une sortie. Au Canada à : www.fr.broan.ca * Basées sur le Kitchen Safety Tips édité par la NFPA.
  • Page 8 HOTTE DE CUISINIÈRE DE LA SÉRIE ALLURE QSE1 ® Page 8 PRÉPAREZ L’EMPLACEMENT CAPUCHON DE TOIT CONDUIT ROND DE 17,8 CM CONDUIT DE 8, 3 CM X 25,4 CM OU ROND DE 17,8 CM (Pour évacuation verticale) SOFFITE FIL DU PANNEAU D'ALIMENTATION ÉLECTRIQUE (Branché...
  • Page 9 HOTTE DE CUISINIÈRE DE LA SÉRIE ALLURE QSE1 ® Page 9 PRÉPAREZ LA HOTTE PRÉPAREZ LA HOTTE DÉBOUCHURE SUPÉRIEURE POUR CONDUIT RECTANGU- LAIRE (Retirez pour installer un conduit de rejet d’air à la verticale de 8,3 cm x 25,4 cm) DÉBOUCHURE ARRIÈRE POUR CONDUIT RECTAN- GULAIRE (Retirez RACCORD DE pour installer un...
  • Page 10 HOTTE DE CUISINIÈRE DE LA SÉRIE ALLURE QSE1 ® Page 10 BRANCHEZ LES FILS INSTALLEZ LA HOTTE D’ A LIMENTATION ÉLECTRIQUE AVERTISSEMENT: Afin de prévenir les risques d’électrocution, assurez-vous que le courant ait été inter- OUVERTURE rompu au panneau d’alimentation principal. Verrouillez EN FORME ce dernier ou apposez un indicateur voyant pour éviter que quelqu’un ne remette accidentellement le courant...
  • Page 11: Remplacement De La Lampe

    HOTTE DE CUISINIÈRE DE LA SÉRIE ALLURE QSE1 ® Page 11 FONCTIONNEMENT REMPLACEMENT DE LA LAMPE LENTILLE D’ÉCLAIRAGE Ventilateur : Le ventilateur est contrôlé à l’aide du commutateur à bascule à trois positions de gauche. Faites basculer le commutateur vers la posi- tion de gauche pour un fonctionnement à régime minimal, vers la position centrale pour arrêter le ventilateur et vers la position de froite pour le régime maximum. Un voyant témoin vous indique que le ventilateur est en marche. Éclairage : L’éclairage est contrôlé à l’aide du commutateur à bascule à trois positions de droite. Faites basculer le commutateur vers la position de gauche pour un éclairage minimal, vers la position centrale pour éteindre l’éclairage et vers la position de droite pour un éclairage maximum. Pour retirer la lentille d’éclairage, tirez sa languette vers l’avant puis tirez vers le bas. ENTRETIEN AVERTISSEMENT : Afin de prévenir les risques d’électrocution, interrompez le courant avant de procéder à...
  • Page 12 GARANTIE LIMITÉE DE UN AN DE BROAN-NUTONE Broan-NuTone garantit à l’acheteur consommateur original de ses produits qu’ils sont exempts de vice de matériaux ou de fabrication pour une période de un an à compter de la date d’achat original. IL N’Y A PAS D’AUTRES GARANTIES, EXPRIMÉES OU IMPLICITES, INCLUANT MAIS NON LIMITÉES AUX GARANTIES IMPLICITES DE QUALITÉ MARCHANDE ET DE CONVENANCE DANS UN BUT PARTICULIER.

Table of Contents