Replacing An Optical Drive - Lenovo H430 Hardware Replacement Manual

3. Remove the four screws that secure the hard disk drive to drive bay.
4. Remove the hard disk drive by pulling it straight out of the drive bay.
5. Slide the new hard disk drive into the drive bay.
6. Secure the new hard disk drive to the drive bay with the four screws.
7. Connect the power and data cables to the hard disk drive. Refer to "Identifying
parts on the system board".
8. Refer to "Completing the installation".

Replacing an optical drive

Attention:
Do not remove the computer cover or attempt any repair before reading the
"Important safety information" in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM, go to the Support Web site at http://consumersupport.lenovo.com.
To replace an optical drive
1. Remove the computer cover. Refer to "Removing the computer cover".
2. Remove the front bezel. Refer to "Removing and replacing the front bezel".
3. Disconnect the data and power cables from the rear of the optical drive.
4. Remove the two screws that secure the optical drive to drive bay.
24
Hardware Replacement Guide