Replacing A Memory Module - Lenovo H430 Hardware Replacement Manual

Lenovo h4 series hardware replacement guide v3.0
Hide thumbs Also See for H430:
Table of Contents

Advertisement

Replacing a memory module

Attention:
Do not remove the computer cover or attempt any repair before reading the
"Important safety information" in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM, go to the Support Web site at http://consumersupport.lenovo.com.
To replace a memory module:
1. Remove the computer cover. Refer to "Removing the computer cover".
Note: For this procedure, it helps to lay the computer on its side.
2. Locate the memory module connectors. Refer to "Locating components".
3. Remove the memory module being replaced by opening the retaining clips as
shown.
4. Position the new memory module over the memory connector. Make sure the
notch
on the memory aligns correctly with the connector key
system board. Push the memory module straight down into the connector until
the retaining clips close.
22
Hardware Replacement Guide
on the

Advertisement

Table of Contents
loading

This manual is also suitable for:

H415H405H420H410

Table of Contents