Sony VGC-RA810G - Vaio Desktop Computer Replacement Instructions

These easy instructions are intended to guide you through the replacement process.
To avoid electric shock please make sure product is turned off and disconnected from the power
source. Remove jewelry before you begin work to avoid scratching the surface of your desktop
computer.*
Place your desktop computer on a clean, stable and covered surface to avoid damage to the
computer's case.
Follow the ESD (Electrostatic Discharge) damage prevention instructions:
o Hold parts by the edges, away from exposed circuitry when possible.
o Do not walk around excessively as this promotes static build-up.
The appearance of the electronic components shown in the illustrations may be different from the
components shipped. This slight difference does not affect the accuracy of these instructions.
* Sony is not responsible for any loss of data associated with your computer or any damage caused by
incorrect handling of the computer under these procedures. The terms of your Sony Limited Warranty
continue to apply.
Left
Side Panel
Step 1
. CAUTION!
Disconnect the power cord.
Failure to do so can result in
unit damage or personal
injury.
Place your PC on a solid
surface with the left side panel
facing towards you.
P/N 994629200 Rev. C
VGC-RA8xx Series Hard Disk Drive
IMPORTANT!
PLEASE READ BEFORE YOU START
*
Step 2
.
To remove the side panel, locate
the release tab and press it down as
shown. Lift up the panel and place it aside.
Replacement Instructions
1/2
[2]
[1]
Step 3
.
The PC should be with
its inside facing to you. Identify
the location of the hard drive's
connections as shown: the serial
ATA cable is [1] and power cable
[2].