Table of Contents
Advertisement
14
Controls & Settings
SYSTEM-MONITORING ALARMS
Alarm Reset Button
Responding to Alarms (Audible Tones & Indicator Lights)
Your refrigerator's control system can convey the following information through
audible tones and the alarm indicator lights.
Alarm
Indicator
Name
Light
On
(light is
Steady
Green
Door
Flashing
Ajar
Green
High
Flashing
Temp
Amber
Power
Flashing
Failure
Amber
The electronic control system continuously
monitors your refrigerator/freezer for temperature
consistency, doors left ajar, and power failures.
Variances from normal operating conditions are
communicated by audible tones and a set of four
status indicator lights.
NO
NOTE
NO
NO
NO
Indicator Lights
Each time you make settings on the control panel, a
single audible tone acknowledges your input.
Audible
Tones
Condition
Alarm system is not active
off)
while Freezer and Fresh
Food compartments are
cooling toward the current
temperature settings.
Alarm system is active.
Freezer or Fresh Food
door has been open for
over five minutes.
Freezer or Fresh Food
compartment has been too
warm (45° F or higher) for
over an hour.
A power outage was
detected.
TE
TE
TE
TE
How To Respond
If Freezer and Fresh Food
compartments do not match your
temperature settings in three hours,
expect the control system to signal
other conditions. If cooling does not
stabilize toward your current settings,
call 1-877-435-3267 for assistance.
No response required.
Close door to disable and reset alarm.
Press Alarm Reset button to turn off
alarm. If temperatures do not improve,
call 1-877-435-3267 for assistance.
Press Alarm Reset button to turn off
alarm and again to reset. Check if the
power failure lasted long enough to
affect stored food temperatures.
Advertisement
Table of Contents
