Brady GlobalMark 2 User Manual page 265

Error Messages
Note:
The table below shows the error code reported by the system firmware, the
condition that generated that error code, the error message, the user action required
to clear the error message, and any additional information.
When a print job is canceled because of an error condition, the printer attempts to
eject and cut off the unfinished print job (where doing so will not harm the printer).
In instances where that is not possible, the error message provides additional
instructions for removing the partial output and returning the printer to a usable
condition.
Error Messages
TABLE 1.
C-2
Error Messages
When an error message appears, it remains on the screen until you correct
the error condition.
Code
15 Close printer cover.
16 Close printer cover, and advance and
shear tape.
17 Close printer cover.
18 None
19 Remove partial output, reload tape,
then advance and shear.
48 Install tape with valid memory cell.
49 Install tape.
50 Install tape with valid memory cell.
51 Install tape with valid memory cell.
52 Install tape with valid memory cell.
53 Reinstall tape or install new tape.
54 Clear tape jam.
User Action