Brady GlobalMark 2 User Manual page 199

1 sets a positive change of .001 inch (.0025 mm)
-
1 sets a negative change of .001 inch (.0025 mm)
2 sets a positive change of .002 inch (.005 mm)
-
2 sets a negative change of .002 inches (.005 mm)
Where the change occurs depends upon the field you set:
In the Horizontal(x) field:
•
•
In the Vertical(y) field:
•
•
Figure 10-6 may help show how your calibrations affect your labels. The
intersection of the x,y axes represents the center point of your label:
Leading edge
10-12
Calibrating the Cutter
Positive values adjust the cutter toward the machine.
Negative values adjust the cutter toward the leading edge of the tape.
Positive values adjust the cutter toward the bottom edge of the tape.
Negative values adjust the cutter toward the top edge of the tape.
Top edge
Bottom edge
Figure 10-6. Cutter calibration axes
Machine