Black Widow BW 2450 User Manual

1 relay / 4 button series

Advertisement

Quick Links

BW2450.qxd
6/11/2009
1 RELAY / 4 BUTTON SERIES
VEHICLE SECURITY SYSTEM
Button 1
Button 3
Transmitter styles may vary
Standard Features:
Two 4-Button Remote Transmitters
Status indicator (LED)
Valet / override switch
Multi-tone siren (115dB)
Dual stage impact detector
Flashing parking lights
Remote panic
Remote sensor bypass
Passive or active arming
Anti-carjacking mode
Optional Features:
Starter disable
Keyless entry
Auxiliary Function
2nd Auxiliary Function
Remote trunk or hatch release
Illuminated entry
Hood and trunk protection
Remote auto start
Power window roll up
Back-up battery w/charging circuit
Perimeter sensor
Note: Some features may require additional
parts and labor, and may not be appropriate for
certain vehicles. Consult your authorized dealer.
4:12 PM
Page 1

System Operation

Button 2
ARMING OPERATION
To arm the system press transmitter button 1:
• The siren will chirp once.
• The parking lights will flash once.*
Button 4
• The doors will lock.*
• The LED will start flashing within 5
seconds and the system will be armed.
After Arming, if a bad sensor or an open
zone is detected, the siren will chirp and the
parking lights will flash 4 times to indicate a
zone is open. The system will ignore that
input, keeping all other areas protected.
While Armed, the system will trigger if:
• The doors are opened.
• The shock sensor detects an impact.
• The hood or trunk is opened.
When triggered, the siren will soundand the
parking lights will flash* for 50 seconds.
If the same input triggers the system 3 times
during a single arming cycle, the system will
bypass that input, keeping other zones
protected, until the next arming cycle.
If the shock sensor detects a light impact to
the vehicle, the siren will chirp and the
parking lights will flash 3 times to warn away
the potential intruder.
*
Optional Feature
PASSIVE ARMING
The passive arming feature allows the system
to arm itself automatically without user
intervention. The Passive Arming feature may be
enabled during installation.
1

Advertisement

Table of Contents
loading

Summary of Contents for Black Widow BW 2450

  • Page 1: System Operation

    BW2450.qxd 6/11/2009 4:12 PM Page 1 1 RELAY / 4 BUTTON SERIES VEHICLE SECURITY SYSTEM System Operation Button 1 Button 2 ARMING OPERATION To arm the system press transmitter button 1: • The siren will chirp once. • The parking lights will flash once.* Button 3 Button 4 •...
  • Page 2: Disarming Operation

    BW2450.qxd 6/11/2009 4:12 PM Page 2 To arm the system passively: REMOTE PANIC 1. Turn the ignition key off. In the event of an emergency, the system’s siren can be triggered for 60 seconds to 2. Exit the vehicle and close all doors. attract attention.To activate the Panic Feature, •...
  • Page 3: Optional Trunk Release

    BW2450.qxd 6/11/2009 4:12 PM Page 3 the system is in valet mode, or turn If the anti-carjack feature is triggered: off indicating valet mode exit. • The system will provide no indications for 60 seconds. OPTIONAL TRUNK RELEASE • After 60 seconds, the siren will chirp for Press button 3 for approximately 3 seconds 10 seconds providing time to press the to open the trunk.
  • Page 4 BW2450.qxd 6/11/2009 4:12 PM Page 4 Installation Instructions Before you begin the installation internal jumper next to the relay as shown on the back page diagram. NOTE: Do not • Read the INSTRUCTIONS! connect to the headlight circuit. • Always use a multi-meter verify wiring. •...
  • Page 5 BW2450.qxd 6/11/2009 4:12 PM Page 5 shows ground when the door is open. optional door lock relay module. • VIOLET WIRE - Positive door trigger (+). • BLUE WIRE - unlock output (-) 500mA. Connect to the door switch circuit wire that •...
  • Page 6 BW2450.qxd 6/11/2009 4:12 PM Page 6 Entering Programming automatically lock with Passive Arming. Arming Mode. Select either manual arming To enter System Programming: (Active) or automatic arming (Passive). 1. Turn on ignition. Anti-Carjacking Activation. Enables or 2. Within 5 seconds, press valet switch 5 disables the anti-carjacking feature.
  • Page 7: Reverse Polarity

    BW2450.qxd 6/11/2009 4:12 PM Page 7 locations. (Example: If only one transmitter is second transmitter. used, repeat step 3 two times to remove any • The siren will chirp once. previously programmed transmitters.) 4. Press Button 4 on Car 1’s transmitter. •...
  • Page 8: Wiring Diagram

    BW2450.qxd 6/11/2009 4:12 PM Page 8 WIRING DIAGRAM RELAY WIRING DIAGRAMS POSITIVE TRIGGER NEGATIVE TRIGGER TO WIRE IN VEHICLE TO WIRE IN VEHICLE (-) OUTPUT (-) OUTPUT FROM ALARM FROM ALARM +12V +12V © 2009 64-2450 6/09 Rev. 2...

Table of Contents