Main Mix Outputs - Mackie SR24•4 Owner's Manual

the submix bus signal; or
SECOND click. This also provides a submix
out connection, but the submix signal is
interrupted at that point.
Layout
and Function
eral places on the rear panel for your mixing
pleasure. Near the middle of the panel you
will find the LEFT, RIGHT and MONO
MAIN outputs. To the left and up a little are
TAPE OUT L and R, and up in the left cor-
ner are MAIN OUTS L and R. All of these
outputs are derived from the main left and
right mix buses.
30
Insert the plug just to
the FIRST click. Do not
push the plug all the way
in. This connection al-
lows you to tap a direct
out without interrupting
Insert the plug all the way in to the
MONO PLUG
Direct out with no signal interruption to master.
Insert only to first "click"
MONO PLUG
Direct out with signal interruption to master.
Insert all the way in to the second "click"

MAIN MIX OUTPUTS

The main SR24•4 outputs appear at sev-
RIGHT LEFT
MAIN OUT MAIN OUT
RIGHT & LEFT MAIN OUT
The stereo MAIN OUTS outputs [8]
appear on the two connectors near the center
of the mixer labeled, appropriately enough,
RIGHT MAIN OUT and LEFT MAIN OUT.
These are male XLR-type connectors, de-
signed to mate with a standard mic cable.
The RIGHT main out and LEFT main out
outputs are electronically balanced, with pin 1
connected to ground, pin 2 to signal "hot" (or
"high" or "+") and pin 3 to signal "cold" (or
"low" or "–"). With the master fader at unity,
nominal output level is +4dBu.
MONO MAIN OUT
The MONO MAIN OUT output [9] is a
Channel Insert jack
sum of the left and right mix buses, buffered
with its own electronically balanced output
amplifiers. Like the right main mix and left
main mix, the MONO MAIN OUT appears
on a male XLR-type connector near the center
of the rear panel. Pin 1 is ground, pin 2 is
Channel Insert jack
"hot" (or "high" or "+") and pin 3 is "cold."
There is an OUTPUT LEVEL control [10]
to trim the level of the MONO MAIN OUT
signal level. With the master fader at unity,
nominal output level is +4dBu.
MAIN OUTS L & R
The main mix outputs also appear at the
MAIN OUTS L and R
upper left corner of the rear panel [11].
These jacks carry the same signals as the
RIGHT main mix and LEFT main mix
connectors.
MAIN OUTS L and R are impedance
balanced 1 /
jacks with ground wired to sleeve, signal "hot"
(or "high" or "+") to the tip and signal "cold"
(or "low" or "–") wired to the ring. You can
connect either balanced or unbalanced inputs
to these outputs. Nominal level is 0dBu.
OUTPUT
LEVEL
+6
O O
/ " TRS jacks near the
1
4
" TRS (tip-ring-sleeve) phone
4
MONO
MAIN OUT
BALANCED
OUTPUTS
PIN 2 = HOT
PIN 3 = COLD