4. Installation ............... 12 4.1 Rack mounting ..............12 4.2 Cable connections ............12 5. Specifications ............13 Thank you Congratulations! In purchasing the BEHRINGER EURORACK you have acquired a mixer whose small size belies its incredible versatility and audio performance.
A list of authorized resellers can dangerous voltage inside the moving the cart/apparatus be found on BEHRINGER’ s website behringer. com under enclosure - voltage that may be suffi cient to constitute a combination to avoid “Where to Buy”, or you can contact the MUSIC Group offi ce risk of shock.
Page 4
EURORACK UB1204FX-PRO/UB1204-PRO User Manual • connection or operation of the unit in any way “Support” at behringer. com. If your country is not (3) This warranty does not detract from the seller’ s listed, please check if your problem can be dealt with...
Mix: Setting the volume level, frequency distribution and positioning of the • Should your BEHRINGER product malfunction, it is our intention to have it individual signals in the stereo field, level control of the total mix to match repaired as quickly as possible. To arrange for warranty service, please contact the recording devices/crossover/power amplifier(s).
EURORACK UB1204FX-PRO/UB1204-PRO User Manual 2. Control Elements and Connectors 2.1.2 Equalizer This chapter describes the various control elements of your mixing console. All controls, switches and connectors will be discussed in detail. 2.1 Mono channels 2.1.1 Microphone and line inputs Fig.
EURORACK UB1204FX-PRO/UB1204-PRO User Manual SOLO When the PRE switch is pressed, aux send 1 is sourced pre-fader. The SOLO switch (UB1204FX-PRO only) is used to route the channel signal to the solo bus (Solo In Place) or to the PFL bus (Pre Fader Listen). This enables you to AUX 2 (FX) monitor a channel signal without affecting the main output signal.
EURORACK UB1204FX-PRO/UB1204-PRO User Manual 2.3 Connector panel and main section AUX SEND 2 Whereas it was useful to trace the signal flow from top to bottom in order to gain The AUX SEND 2 connector outputs the signal you picked up from the individual an understanding of the channel strips, we now look at the mixing console from channels using the FX control.
2-TRACK OUTPUT link. machine (e.g. DAT recorder). They can also be used as stereo line input. Alternatively, the output signal of a second EURORACK or BEHRINGER ULTRALINK POWER PRO MX882 can also be connected. If you connect a hi-fi amplifier with a source selection switch to the 2-TRACK INPUT, you can easily switch between additional The blue POWER LED indicates that the device is switched on.
EURORACK UB1204FX-PRO/UB1204-PRO User Manual LEVEL METER PFL (UB1204FX-PRO only) The high-precision level meter accurately displays the appropriate signal level. The PFL LED indicates that the peak meter is set to PFL mode. LEVEL SETTING: PHONES When recording to a digital device, the recorder’s peak meter should not exceed You can connect headphones to this 1/4"...
EURORACK UB1204FX-PRO/UB1204-PRO User Manual 3. Digital Effects Processor ALT 3-4 OUTPUTS The ALT 3-4 outputs are unbalanced and carry the signals of the channels that you have assigned to this group using the MUTE switch. This can be used to route a subgroup to a further mixing console for example, or or it could be used as a recording output working in tandem with the main output.
EURORACK UB1204FX-PRO/UB1204-PRO User Manual 4. Installation 4.2.1 Audio connections Please use commercial RCA cables to wire the 2-track inputs and outputs. 4.1 Rack mounting You can, of course, also connect unbalanced devices to the balanced The packaging of your mixing console contains two 19" rack mount wings which input/outputs.
EURORACK UB1204FX-PRO/UB1204-PRO User Manual 5. Specifications Balanced ¼" TRS connector strain relief clamp Mono Inputs sleeve ring Microphone Inputs (IMP “Invisible” Mic Preamp) Type XLR, electronically balanced, discrete input circuit Mic E.I.N. (20 Hz - 20 kHz) sleeve ground/shield @ 0 Ω source resistance -134 dB / 135.7 dB A-weighted ring @ 50 Ω...
Page 14
1/3 as far left as possible, channels 2/4 as far right as possible. Reference = +6 dBu. Type 1/4" TS connector, unbal. BEHRINGER is constantly striving to manintain the highest professional standards. As a result of these efforts, Impedance approx. 120 Ω...
Page 15
EURORACK UB1204FX-PRO/UB1204-PRO User Manual FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION EURORACK UB1204FX-PRO/UB1204-PRO MUSIC Group Services US Inc. Responsible Party Name: 18912 North Creek Parkway, Address: Suite 200 Bothell, WA 98011, Phone: +1 425 672 0816 Phone/Fax No.: Fax: +1 425 673 7647 EURORACK UB1204FX-PRO/UB1204-PRO complies with the FCC rules as mentioned in the following paragraph: This equipment has been tested and found to comply with the limits for a Class B...