Behringer X32 DIGITAL MIXER User Manual page 10

10
X32 DIGITAL MIXER Preliminary User Manual
01
Ch01
01:
analog out
home
Edit Output Assignment
Analog Output Current Setting
MixBus
Output 01
Output 02
Output 03
Output 04
Output 05
Output 06
Output 07
Output 08
Output 09
Output 10
Output 11
Output 12
Output 13
Output 14
Select
Output Signals can be freely assigned from any internal signal to any of the
following outputs:
• 16x analog local XLR outputs (with adjustable digital delay for
time-alignment of speakers)
• 6x auxiliary sends on ¼" TRS outputs + 2x AES/EBU outputs
• 16x personal monitoring using the console's P-16 Bus output connector
01
Ch01
01:
con g
home
clip
-6
48V
-12
Reverse
-18
-24
-30
Link Lo Cut
-36
-42
+0.0 2.0
dB Hz
-48
-54
Gain Lo Cut
Gain Lo Cut
+0.00 20
dB Hz
Link Lo Cut
Input Channels 1-32 are pre-configured to use the first 32 input signals,
but can be patched to use any other available signal on the audio engine as well,
including mix bus/sub group outputs. Changes of the Channel Source can be
made on the Preamp Config page.
A: S16
0:00 - 0:00
B: -
aux out p16 out card out aes50-a
Category Processed Output Signal Tap
OFF OFF Pre EQ
Main (LRC) Main L Post EQ
Mix Bus Main R Pre Fader
Matrix Main C/M Post Fader
Direct Out Main Bus 01
Monitor Main Bus 02
Main Bus 03
Main Bus 04
Main Bus 05
Main Bus 06
Main Bus 07
Main Bus 08
Main Bus 09
Select Select
Assign
A: S16
0:00 - 0:00
B: -
gate dyn eq
Insert Position
t
In
Delay Pre
ft
0.3
Source
0.10 m
OFF
Input 01 0.03 ms
Input 02
Input 03
Input 04
Delay
Input 05
Input 06
Source Delay
Input 0.3
ms
Select Delay Insert
14:09
A: 48K
: 37
C: XUF
aes50-b
0.3 ft
0.10 m
0.3
ms
Delay
Delay
Delay
Select
0.3 ms
Set Delay
Any and all of the above signals can also be mirrored in blocks of 8 signals on
either one of
• 48x channels on AES50 port A
• 48x channels on AES50 port B
• 32x channels on USB/Firewire interface card
14:11
A: 48K
: 37
C: XUF
sends main
Ins Post
Insert
OFF
InsFX 1L
InsFX 1R
InsFX 2L
InsFX 2R
InsFX 3L
InsFX 3L
Ins Pos Insert
PRE InsF
Connect
Aux Return Channels 1-8 are pre-configured to use the 6 aux input signals,
and the two USB playback outputs, but can be patched to use any other available
signal of the console as well.
FX Return Channels 1L-4R control the 4 stereo output signals of side-chain FX1-4.