Advertisement
Fig. 1
Fig. 4
Fig. 8
ENGLISH
Location, Fig. 1
Do not site the room thermostat in a draught, in
direct sunlight or close to appliances giving off
heat (e.g. television set.)
Fixing, Fig 2 and 3
Make sure the supply voltage to the system is
disconnected before commencing installation
or subsequentially removing the thermostat
cover.
Fix the base moulding on a flush box. The
temperature range can be limited by moving
the two springs on the back of the setting dial,
Fig 4.
Wiring, Fig 5, 6 and 7
Switch function: SPDT, Fig 8
230 V, 50 - 60 Hz, 10 (4) A
Min. contact load: 150 mA
Note: Always connect the live (L) to terminal .
Instructions
RMT-230, RMT-230T
Fig. 2
RMT230
T
t
1 3 2
N
L
Fig. 5
When the room thermostat is connected to an
inductive load, without noise suppression, there
might be risk of radio and TV interference.
RMT versions with parallel accelerator Rp, will
have a lower temperature differential when
terminal is connected as shown in Fig. 6 and
7.
RMT-230T only
RMT-230T will set back the temperature by 5K,
when the built-in resistance Rn is connected as
shown in Fig. 7.
Note:
A means of disconnecting the supply with a
contact separation of at least 3mm in all poles
must be incorporated in the fixed wiring,
according to BS 3955. This product does not
require an earth connection.
RMT230
T
t
s s
Rp
4
1 3 2
N
L
Fig. 6
Fig. 3
RMT230T
T
t
s s
Rp
Rn
6
4
5
1 3 2
N
L
Fig. 7
Advertisement
Related Manuals for Danfoss RMT-230
Summary of Contents for Danfoss RMT-230
- Page 1 Instructions RMT-230, RMT-230T Fig. 1 Fig. 2 Fig. 3 RMT230 RMT230 RMT230T 1 3 2 1 3 2 1 3 2 Fig. 4 Fig. 5 Fig. 6 Fig. 7 Fig. 8 ENGLISH Location, Fig. 1 When the room thermostat is connected to an Do not site the room thermostat in a draught, in inductive load, without noise suppression, there direct sunlight or close to appliances giving off...
-
Page 2: Choix De L’emplacement
Fig. 1 Fig. 2 Fig. 3 RMT230 RMT230 RMT230T 1 3 2 1 3 2 1 3 2 Fig. 4 Fig. 5 Fig. 6 Fig. 7 Fig. 8 FRANCAIS Choix de l’emplacement, Fig. 1 Le thermostat RMT avec résistance anticipatrice Le thermostat RMT détecte une température a un faible différentiel de température pour ambiante considérée comme représentative. - Page 3 DANSK ESPAOL Placering, Fig. 1 Instalación, Fig. 1 Placer ikke rumtermostaten i træk, i direkte sol No instalar el termostato en una corriente de eller i nærheden af apparater der afgiver varme aire, en un punto soleado o cerca de una fuente (fx.
- Page 4 SVENSKA NEDERLANDS SUOMEKSI Placering, Fig. 1 Plaastsing, afb. 1 Sijoituspaikka, kuva 1 Placera inte rumstermostaten i drag, direkt sol Plaats de thermostaat op ooghoogte, bij Älä sijoita huonetermostaattia vetoiseen eller i närheten av apparater som avger värme. voorkeur op een binnemuur, waar de RMT kohtaan, suoran auringonpaisteen kohteeksi tai niet direct wordt beïnvloed door koude lämpöä...