Name Of Parts - Fujitsu Inverter ASTB09LDC Operating Manual

NAME OF PARTS

Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
●
When kept on pressing the MANUAL
AUTO button for more than 10 seconds,
the forced cooling operation will start.
●
The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's
use.
●
When the forced cooling operation starts
by any chance, press the START/STOP
button to stop the operation.
3 Indicator (Fig. 3)
4 Remote Control Signal Receiver
5 OPERATION Indicator Lamp (red)
6 TIMER Indicator Lamp (green)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 18 Auto Restart).
7 AIR CLEAN Indicator Lamp (green)
8 COIL DRY Indicator Lamp (orange)
9 Intake Grille (Fig. 4)
0 Air Filter
A Air Flow Direction Louver
B Right-Left Louver
(behind Air Flow Direction Louver)
C Drain Hose
D Electrical Air Cleaning Filter
E Power Supply Cord
F Power Supply Plug
Fig. 5 Outdoor Unit
G Intake Port
H Outlet Port
I Pipe Unit
J Drain port (bottom)
Fig. 6 Remote Control Unit
K Signal Transmitter
L MASTER CONTROL button
M FAN CONTROL button
N START/STOP button
O AIR CLEAN button
P COIL DRY button
Q SET button
R SET TEMP. button (
S SLEEP button
T SWING button
U TIMER MODE button
V TIMER SET (
/
W TEST RUN button
● This button is used when installing the
conditioner, and should not be used un-
der normal conditions, as it will cause the
air conditioner's thermostat function to op-
erate incorrectly.
● If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the Indoor Unit's OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
● To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
X CLOCK ADJUST button
Y RESET button
Z Remote Control Unit Display (Fig. 7)
[ Temperature SET Display
\ Transmit Display
] Operating Mode Display
` Fan Speed Display
a AIR CLEAN Display
b SWING Display
c COIL DRY Display
d T imer Mode Display
e SLEEP Display
f Clock Display
/ )
)buttons
4