Connection Summary - Minimum System Wiring - Baldor DSM S Series Installation Manual

4.5 Connection summary - minimum system wiring

As a guide, Figure 13 shows an example of the typical minimum wiring required to operate the
DSM in conjunction with a NextMove ESB controller.
X12
REL COM
REL NC
Note: For simplicity, the NextMove ESB's 24 V
power supply on connector X1 is not shown.
Figure 13 - Example minimum system wiring (flying leads)
4-10 Input / Output
X2
NextMove ESB
DIR0+
+5V
STEP0
(NC)
DGND
Motor
power
supply
Red - 12-48 VDC / 12-75 VDC
Black - 0 V
Blue - Direction
White - Optocoupler reference
Orange - Step clock
Brown - Enable
CBL055-501
PC USB port > SPI connection
(required only during setup)
www.baldormotion.com
Ferrite & filter
not shown.
DSM
PC
MN1940