Sleep Mode; Portaholder ™ Installation - Baratza Vario Operation Manual

sponding button (Espresso, Filter,
or Press) and hold for 3 seconds.
The time shown in the LCD display
will blink to confirm the setting is
stored.
3. Repeat steps 1 and 2 above for
each of the other two buttons.
The quantity of ground coffee you
need depends on the type of bean,
coarseness of the grind, brewing
method and personal taste. With
use, you will find the most suitable
settings for your personal taste.

Sleep Mode

This is a programmable feature to
allow the lights and display to turn
off after a pre selected amount of
time elapses since last grinding.
Also there is the ability to "force"
it to sleep mode by pressing and
holding the START button for 3
seconds. As soon as the lights
turn off you can release the button.
Touching any button will "wake it
up" (but will not perform the func-
tion of the button pressed). To se-
lect sleep mode delay, press and
hold the MANUAL button for 3 sec-
onds until the display shows "S00".
"S 00" means Sleep mode never
happens. The up or down arrow al-
lows selection for 3 minute delay
(S03), 5 minute (S05), 10 minutes
(S10), 20 minutes (S20), 30 min-
utes (S30) or infinity (S00) . Press
the MANUAL button to store the
value you desire.
PortaHolder
Insert the PortaHolder
grinder until it clicks. Then insert
your porta filter into the PortaHol-
der by tipping the basket down so
™
the lip of the porta filter slides un-
der and gets hooked by the hook
bracket at the top rear of the Porta-
Holder while the base of the bas-
™
ket is supported by the two metal
fingers that extend from the Por-
taHolder If the porta filter bas-
™
ket is not horizontal in the holder,
remove the screw and move the
bracket higher or lower in order to
level the portafilter basket.
To use, insert your porta filter
into the PortaHolder
desired dose button, then press
START. The grinder will run for the
preset dose time and stop automat-
ically.
7
Installation
™
into the
™
. Press the
™