Check Thermostat Operation; Heating System; Cooling System; Fan Operation - Emerson 1F86-0244 Instructions Manual

Blue 2” single stage thermostat
Table of Contents

Advertisement

OPERATION

CHECK THERMOSTAT OPERATION

If at any time during testing your system does not operate
properly, contact a qualified service person.
Turn on power to the system.

Fan Operation

If your system does not have a G terminal connection, skip to

Heating System.

1. Move fan switch to ON position. The blower should begin to
operate.
2. Move fan switch to AUTO position. The blower should stop
immediately.
Heating System
1. Move SYSTEM switch to HEAT position. If the auxiliary
heating system has a standing pilot, be sure to light it.
2. Press
to adjust thermostat setting to 1° above room
temperature. The heating system should begin to operate.
3. Press
to adjust temperature setting below room
temperature. The heating system should stop operating.

Cooling System

CAUTION
!
To prevent compressor and/or property damage, if the
outdoor temperature is below 50
the cooling system.
1. Move SYSTEM switch to COOL position.
2. Press
to adjust thermostat setting below room
temperature. The blower should come on immediately on
high speed, followed by cold air circulation. However, if the
setpoint temperature is flashing, the compressor lockout
feature is operating (see Configuration menu, item 5).
3. Press
to adjust temperature setting above room
temperature. The cooling system should stop operating.
CAUTION
!
Do not allow the compressor to run unless the
compressor oil heaters have been operational for 6
hours and the system has not been operational for at
least 5 minutes.
6
F, DO NOT operate
o

Advertisement

Table of Contents
loading

Table of Contents