Related Manuals for Danfoss FMT230D
Summary of Contents for Danfoss FMT230D
- Page 1 Electronic fl ush mounted FMT230D dial setting room thermostat with LCD display User & Installation Instructions Certification Mark...
- Page 2 Index Installation Instructions 3-11 User Instructions 12-15...
-
Page 3: Installation Instructions
Installation Instructions Features FMT230D Temperature Range 5 - 30°C Setting dial and LCD display Chrono-proportional or On/Off control Heat or cool operation Output relay contact rating 10-264 Vac, 50/60 Hz, 3 (1) A Switching action 1 SPDT Type 1B Power supply 230 Vac ±... - Page 4 Mounting The product is designed to mount on to a standard one-gang fl ush mounted electrical accessory box having a minimum depth of 25mm. Fixing screws and screw blanking caps are provided with the product. Rear View of Thermostat Terminal Blocks M3.5 screws Installer DIL Switches...
- Page 5 Fix at a height of 1.5m approx from the fl oor, away from draughts or heat sources such as radiators, open fi res or direct sunlight. Please Note: This product should only be installed by a qualifi ed electrician or competent heating installer and should be in accordance with the current edition of the IEEE wiring regulations.
- Page 6 Wiring 230 Vac...
-
Page 7: Dil Switch Settings
DIL switch settings Slide the DIL switches to the settings required. ON/OFF - boiler switches ON when below set temperature and OFF when above. CHRONO - energy saving feature which fi res the boiler at regular intervals to maintain a set temperature, achieving a constant ambient environment for the user. - Page 8 DIL Switch Settings HEAT COOL CHRONO ON/OFF 3/9 CYCLES 6/12 CYCLES 9/12 CYCLES 3/6 CYCLES...
- Page 9 Mounting (continued)
-
Page 10: Resetting The Unit
Resetting the unit When power is fi rst applied, remove the dial and press the RESET button for 2 seconds. RESET Button... -
Page 11: Locking & Limiting
Locking & Limiting * Locking - setting the thermostat at a temperature which cannot be altered by the user. Limiting - allowing the user to alter the temperature within a predefi ned range, which is less than the full range of the product (i.e. -
Page 12: What Is A Room Thermostat
What is a room thermostat? ... an explanation for householders A room thermostat simply switches the heating system on and off as necessary. It works by sensing the air temperature, switching on the heating when the air temperature falls below the thermostat setting, and switching it off once this set temperature has been reached. - Page 13 being controlled at a lower temperature, and saves energy. The heating system will not work if a timeswitch or programmer has switched it off. The way to set and use your room thermostat is to fi nd the lowest temperature setting that you are comfortable with, and then leave it alone to do its job.
-
Page 14: User Instructions
User Instructions Display The LCD displays actual room temperature until the setting dial is moved. LED Indicators Power on - Green (left hand LED). Thermostat output on - Red (right hand LED). Setting the temperature Turn setting dial to required temperature. The selected temperature will fl... - Page 15 Thermostat status A fl ame symbol ( ) will be shown whenever the thermostat is in heating mode, a snowfl ake symbol ( ) will be lit when the thermostat is in cooling mode. To change mode please refer to DIL switch setting on page 8.
- Page 16 www.danfoss.com/BusinessAreas/Heating This product complies with the following EC Directives: Electro-Magnetic Compatibility Directive. (EMC) (2004\108\EC) Low Voltage Directive. (LVD) (2006\95\EC) Part No 25937v01 01/08...