Network Ports - Altigen AltiWare ACC 5.2 Administration Manual

If AltiWare ACC 5.2 is behind a firewall/NAT router, you need to open TCP and UDP ports
according to the following table:
For external VoIP connection through a firewall
Remote AltiGen IP phone/IPTalk to phone service
Remote AltiGen IP phone firmware download (TFTP)
VoIP RTP Port (Voice Stream) for SIP and H.323
SIP Tie Trunk from other AltiGen systems
SIP Trunking Service from carrier
H.323 Tie Trunk
H.245 (Media Capability)
An easy way to find out the RTP/TCP port range(s) for SIP and H.323 is to look in
Note:
AltiWare Administrator View > Current Resource Statistics. All the ports are
listed in the Local Ports column.
Alternatively, you can figure the port range in the following way:
For a single chassis system:
X = 49152
Y = 49152 + Total IP codec channels x 2
For a multi-chassis system, you need to enter multiple ranges:
Gateway ID = 0
X0 = 49152
Y0 = 49152 + Total IP codec channels in GW0 x 2
Gateway ID = 1
X1 = 49152 + 512 x 1

Network Ports

TCP
10032
10064
1720
From X to Y
(See note
below)
AltiWare ACC 5.2 Administration Manual 371
A
P P E N D I X
C
UDP
10060
69
From X to Y
(See note
below)
10060
5060