Physical Location And Type; Setting The Line Properties - Altigen AltiWare ACC 5.2 Administration Manual

Physical Location and Type

You can change the extension's type and location.
Changing the Type
The type of extension—physical or virtual—is set when you create the extension. After
you create the extension, the type is displayed in brackets in the Agent/Supervisor/
Extension list on the left side of the Extension Configuration window.
You can change a Virtual extension to a Physical one, and vice versa.
If you change the type to physical, you can also set the location and configure the line
as discussed in the "Setting the Line Properties" on page 187.
For information about IP extension configuration, see "Setting Up IP Extensions" on page
213.
Assigning a Location to a Physical Extension
When changing a virtual extension to a physical extension, the Location parameters are
available. If you know which board and channel this extension is wired to, you can use
the Prev and Next buttons to select the correct board and channel number for this
physical extension.
Changing the Location
To change the location of a physical extension, select the extension number in the list of
extensions, then click the Prev or Next buttons to change the board and channel
settings until the location you want is displayed. Like other changes, this change isn't
finalized until you click Apply.

Setting the Line Properties

For a physical extension, you can configure hardware options on the port used for the
extensions. To do so, select the extension number in the list of extensions, then click the
Line Properties button to open a dialog box that is specific to the board used for the
extension.
The Line Properties are somewhat different for Quantum Board than for Triton Analog
Station Boards. The subsequent sections deal first with Quantum, then with Triton
Analog Station.
Chapter 15: Extension Configuration
AltiWare ACC 5.2 Administration Manual 187