Configuring The Virtual Mobileext Board; C Hapter - Altigen AltiWare ACC 5.2 Administration Manual

Double-clicking a channel in the Channel Mapping List opens the appropriate
configuration dialog box for that channel.
For information on configuring the T1/E1 trunk, see "Triton T1/E1 Trunk Properties"
•
on page 145.
For information on configuring the Triton Analog Trunk, see "Triton Analog Trunk GS/
•
LS Properties" on page 148.
For information on configuring a Triton Analog Line, see "Triton Analog Station Line
•
Properties" on page 189.
In the main Board Configuration dialog box for the MAX board (see Figure 20 on
page 132) clicking the Board Configuration button opens the following dialog box.
Figure 21. MAX Board Configuration window
This dialog box displays the board serial number, top access card serial number, bottom
access card serial number, DSP clock, board ID, physical ID, and logical ID. You can
choose to configure the board as either T1 or E1, then click OK. Additional steps are
needed to further configure the CAS or PRI protocol in the Protocol Configuration
window, shown in Figure 9 and Figure 10.
(For information on adding and removing mobile trunks, see "Mobile Extension
Configuration" on page 227.)

Configuring the Virtual MobileExt Board

A simulated physical board—MobileExt board—is created if a Triton analog trunk or
Triton T1/PRI trunk is configured as a MobileTrunk. T1, PRI and analog trunks can be
shared for regular incoming and outgoing calls and mobile trunk connections.
Only one gateway can include a MobileExt board, even if the system consists of multiple
gateways.
Configuring the virtual MobileExt board is discussed on page 228 in the chapter "Mobile
Extension Configuration."
Chapter 11: Board Configuration
AltiWare ACC 5.2 Administration Manual 133