Table of Contents
Advertisement
TE9000 / 93000 Service
SECTION 1
Service Procedures
Axle annual service and service after
3 years or 300,000 Km
The following step by step instruction details the essential operations
required for these services. The 3 year service is in effect the same as the
annual service with additional work on the hub and bearing assembly.
Details of these additional procedures can be found in the next section of
this manual.
Summary:
1.
De-adjust Brake
2.
Remove Wheel, Hub and Drum Assembly
3.
4.
5.
Clean Anchor Pin Bushes, Anchor Bracket and
Cam Head
6.
7.
Remove Cam Rollers from Brake Shoes
8.
9.
13. Inspection of Camshafts and Camshaft Bearings
for Play
14. Removal of Camshafts and Camshaft Bearings
15. Replacement of Camshafts and Camshaft Bearings
20. Wheel Bearing Inspection and Greasing
20b. 3 Year Major Hub Service
23. Lubricate Brake Chamber Clevis Pin Assembly
24. Adjust Brakes
To carry out the above procedures in detail continue as follows:
1. DE-ADJUST BRAKE
Using the manual adjustment nut on the slack adjuster fully de-adjust the
brake.
2. REMOVE WHEEL, HUB AND DRUM
ASSEMBLY
Remove hub cap (fig. 1).
Remove hub cap seal. (Note: If this is an 'O' ring discard it.)
Straighten locking tab on tab washer using hammer and chisel (fig. 2).
Remove axle end nut (55mm A/F), and tab washer
(fig. 3).
Install wheel dolly.
FIG. 1
FIG. 2
FIG. 3
7
- Quick Links:
- Axle Installation
- Service Procedures
Hide quick links:
Advertisement
Table of Contents
