Playing Back Via Bluetooth; Listening To An Audio From Bluetooth Device; Displaying Bluetooth Information; Setting Bluetooth Standby - Onkyo CS-355B Instruction Manual

Cd receiver system
Table of Contents

Advertisement

Available languages

Available languages

Playing Back via Bluetooth

Listening to an audio from Bluetooth
device
Note:
• If your mobile phone supports A2DP protocol, its
music will play through the CD receiver.
• You can build a Bluetooth connection with a mobile
phone, an iPod or any other Bluetooth-enabled
devices.
Press the [INPUT] button on the top panel
1
repeatedly to select the "Bluetooth" input.
Tip:
• Alternatively, you can use the remote controller's
[ /LINE] button.
2
Press the [
Bluetooth PAIRING] button on
the top panel. to put the CD receiver into the
pairing mode.
"Pairing..." appears on the CD receiver's display.
If you hold the [
Bluetooth PAIRING] button for
more than 2 seconds during the process of pairing,
the operation will be cancelled.
3
During this period, you can operate the
mobile phone, iPod or Bluetooth-enabled
device to pair with the CD receiver within a
10m range.
For details on the Bluetooth connection, refer to the
user manual of the Bluetooth-enabled device.
The CD receiver may not work as normal
depending on the circumstance even though the CD
receiver is placed within the 10 m range. In such
cases, get the Bluetooth-enabled device closer to
the CD receiver and retry the operation.
4
Once the CD receiver is detected and its
name "Onkyo CR-245BT" appears on the
display of your Bluetooth-enabled device,
select the "Onkyo CR-245BT." If a prompt
requests a password, key in the "0000".
When a Bluetooth connection is established
successfully, the "
and "Bluetooth" appears on the display of the CD
receiver.
" indicator will be solid on
5
Select the desired music and press "
button on your device. The CD receiver
automatically starts playing the audio.
If the "
" indicator is not lit and "Bluetooth"
appears on the display of the CD receiver after 2
minutes have elapsed after "Pairing..." appears, this
means that the pairing is not done successfully.
Perform the above procedure 1 to 4 again.
Note:
• If there is no sound output even after the paring is done
successfully, consult the user manual of the Bluetooth-
enabled device, and then select the
"Onkyo CR-245BT" as the audio output device.
• The CD receiver can store the pairing information of
up to 8 Bluetooth devices. If the pairing is done for the
ninth Bluetooth device, the pairing information of
device connected via Bluetooth in the most past times
is erased.
• The multiple Bluetooth devices cannot be connected
at the same time.

Displaying Bluetooth Information

If you press the [DISPLAY] button during the Bluetooth
connection, the following Bluetooth information
appears.
The information is shown in the following order.
• Audio CODEC
• Sampling frequency

Setting Bluetooth Standby

With Bluetooth Standby, you can set the CD receiver so
that it will be automatically turned on if the Bluetooth
device is operated while the CD receiver is on standby.
The default setting is "Off".
Make settings for this function while CD receiver is in
standby mode.
Press and hold the [
ON/STANDBY] button on
the CD receiver while it is on standby (about 3
seconds).
The "SLEEP" indicator will be dimly-lit.
Note:
• To switch between "On" and "Off" , repeat this
procedure.
/ "
23
En-

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cs-355rCs-355wCs-355Cr-245btD-t05

Table of Contents