Cyber-shot cameras: cyber-shot digital still camera (88 pages)
Summary of Contents for Sony DSC-P41 - Cyber-shot Digital Still Camera
Page 1
DSC-P41/P43 SERVICE MANUAL LEVEL DSC-P41 Ver 1.0 2004.04 US Model Revision History Revision History DSC-P43 Hong Kong Model Tourist Model Japanese Model How to use How to use DSC-P41/P43 Acrobat Reader Acrobat Reader Canadian Model AEP Model UK Model E Model Australian Model Chinese Model Korea Model...
DSC-P41/P43 SPECIFICATIONS x Camera [LCD screen] x BC-CS2A/CS2B Ni-MH battery [System] charger (supplied with the DSC- LCD panel used P43) 3.8 cm (1.5 type) TFT drive Image device 6.85 mm (1/2.7 type) color Total number of dots Power requirements Primary color filter 67 200 (280×240) dots AC 100 to 240V 50/60Hz Total pixels number of camera...
Page 3
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU PUBLISHED BY SONY.
DSC-P41/P43 SECTION 1 SERVICE NOTE 1-1. NOTE FOR REPAIR Make sure that the flat cable and flexible board are not cracked of When remove a connector, don’t pull at wire of connector. bent at the terminal. It is possible that a wire is snapped. Do not insert the cable insufficiently nor crookedly.
1-3. DESCRIPTION ON SELF-DIAGNOSIS DISPLAY Self-diagnosis display • C: ss: ss You can reverse the camera malfunction yourself. (However, contact your Sony dealer or local authorized Sony service facility when you cannot recover from the camera malfunction.) • E: ss: ss Contact your Sony dealer or local authorized Sony service facility.
DSC-P41/P43 SECTION 2 HELP HELP DISASSEMBLY 2-1. FLOW CHART The following flow chart shows the disassembly procedure. 1 Caution label Note: High-voltage cautions 2 Tape (A) HELP Discharging the Capacitor Short-circuit between the two 3 FP-853: CN702 points with the short jig about 10 4 FP-856: CN601 seconds.
DSC-P41/P43 2-2. SY-101 BOARD SERVICE POSITION Rear cabinet block Flush unit ST-098 board Control switch block MS board SY-101 board FP-860 flexible board Lens block Color monitor DSC-P43 only AC power AC IN adaptor Microphone unit Setting the "STILL" or "MOVIE" mode Before turn on the power, you have to keep a switch (SW1) pushed in order to maintain the "STILL"...
DSC-P41/P43 2-3. CIRCUIT BOARDS LOCATION SW-420 CH-146 (included in SY-101) ST-098 CD-501 SY-101 (including CH-146) MS (FP-861) Board Name Function CD-501 CCD IMAGER CH-146 CCD SIGNAL PROCESS (included in SY-101) MS (FP-861) MEMORY STICK CONNECTOR ST-098 FLASH DRIVE SW-420 CONTROL SWITCH, LCD DRIVE SY-101 CAMERA MODULE, CAMERA DSP, LENS DRIVE, SH DSP, (Including CH-146) FRONT CONTROL, AUDIO, DC/DC CONVERTER...
Page 10
DSC-P41/P43 HELP Sheet attachment positions and procedures of processing the flexible boards/harnesses are shown. Caution label SY-101 board Tape (A) Tape (A) HELP...
DSC-P41/P43 3. BLOCK DIAGRAMS Link Link OVERALL BLOCK DIAGRAM (1/2) POWER BLOCK DIAGRAM (1/2) OVERALL BLOCK DIAGRAM (1/2) POWER BLOCK DIAGRAM (1/2) OVERALL BLOCK DIAGRAM (2/2) POWER BLOCK DIAGRAM (2/2) OVERALL BLOCK DIAGRAM (2/2) POWER BLOCK DIAGRAM (2/2)
Page 12
DSC-P41/P43 SECTION 3 3. BLOCK DIAGRAMS 3. BLOCK DIAGRAMS BLOCK DIAGRAMS 3-1. OVERALL BLOCK DIAGRAM (1/2) ( ) : Number in parenthesis ( ) indicates the division number of schematic diagram where the component is located. CD-501 BOARD (1/2) SY-101 BOARD (1/2) SW-420 BOARD (1/2) CP900 LENS BLOCK...
Page 13
DSC-P41/P43 3. BLOCK DIAGRAMS 3. BLOCK DIAGRAMS ( ) : Number in parenthesis ( ) indicates the division number of schematic diagram where the component is located. 3-2. OVERALL BLOCK DIAGRAM (2/2) SY-101 BOARD (2/2) FP-860 FLEXIBLE BOARD CN751 (1/2) DSC-P43 (1/2) J002...
Page 14
DSC-P41/P43 3. BLOCK DIAGRAMS 3. BLOCK DIAGRAMS 3-3. POWER BLOCK DIAGRAM (1/2) ( ) : Number in parenthesis ( ) indicates the division number of schematic diagram where the component is located. SY-101 BOARD (1/2) CONTROL SWITCH BLOCK CN001 Q006, 007 (RL51510) F001 BATT UNREG...
Page 15
DSC-P41/P43 3. BLOCK DIAGRAMS 3. BLOCK DIAGRAMS ( ) : Number in parenthesis ( ) indicates the division number of schematic diagram where the component is located. 3-4. POWER BLOCK DIAGRAM (2/2) SY-101 BOARD (2/2) ST-098 BOARD CN703 CN851 T851 Q703, 706 L701 ST UNREG...
DSC-P41/P43 4-2. SCHEMATIC DIAGRAMS Link Link CD-501 BOARD CD-501 BOARD (CCD IMAGER) FP-860 FLEXIBLE BOARD (CCD IMAGER) FP-860 FLEXIBLE BOARD (JACK) (JACK) SW-420 BOARD SW-420 BOARD MICROPHONE UNIT MICROPHONE UNIT (MA-001) (MA-001) (CONTROL SWITCH, LCD DRIVE) (CONTROL SWITCH, LCD DRIVE) ST-098 BOARD CONTROL SWITCH BLOCK ST-098 BOARD...
Page 18
DSC-P41/P43 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS THIS NOTE IS COMMON FOR SCHEMATIC DIAGRAMS (In addition to this, the necessary note is printed in each block) (For schematic diagrams) 1. Connection • All capacitors are in µF unless otherwise noted. pF : µ Link µF.
Page 19
DSC-P41/P43 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS CD-501 BOARD CD-501 BOARD For Schematic Diagram • Refer to page 4-37 for printed wiring board. Note: Voltage and Waveform of mounted IC801 on CD-501 CD-501 BOARD board can not be measured because this is mounted by the side of the lens.
Page 20
Schematic diagrams of the CH-146 and SY-101 boards are not shown. Pages from 4-9 to 4-26 are not shown.
Page 21
DSC-P41/P43 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS SW-420 BOARD SW-420 BOARD For Schematic Diagram • Refer to page 4-43 for printed wiring board. SW-420 BOARD CONTROL SWITCH, LCD DRIVE (PD BLOCK, SW BLOCK) XX MARK:NO MOUNT NO MARK:REC/PB MODE L203 10uH C219 L202...
Page 22
DSC-P41/P43 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS ST-098 BOARD ST-098 BOARD For Schematic Diagram • Refer to page 4-45 for printed wiring board. ST-098 BOARD FLASH DRIVE (ST BLOCK) T851 D852 XX MARK:NO MOUNT HAU160C030STP NO MARK:REC/PB MODE LND851 XE_H R851 2200 R859...
Page 23
DSC-P41/P43 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS MS BOARD MS BOARD FP-860 FLEXIBLE BOARD FP-860 FLEXIBLE BOARD For Schematic Diagram For Schematic Diagram • Refer to page 4-47 for printed wiring board. • Refer to page 4-48 for printed wiring board. FP-860 FLEXIBLE BOARD MS BOARD (FP-861 FLEXIBLE BOARD) Note: FP-860 flexible board is replaced as block,...
Page 24
DSC-P41/P43 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS MICROPHONE UNIT (MA-001) CONTROL SWITCH BLOCK (RL51510) MICROPHONE UNIT (MA-001) is replaced as block, CONTROL SWITCH BLOCK (RL51510) is replaced as block, so that PRINTED WIRING BOARD is omitted. so that PRINTED WIRING BOARD is omitted. D001 (POWER) LENS COVER...
DSC-P41/P43 4-3. PRINTED WIRING BOARDS Link Link CD-501 BOARD CD-501 BOARD MS BOARD MS BOARD (FP-861 FLEXIBLE BOARD) (FP-861 FLEXIBLE BOARD) SW-420 BOARD FP-860 FLEXIBLE BOARD SW-420 BOARD FP-860 FLEXIBLE BOARD ST-098 BOARD ST-098 BOARD COMMON NOTE FOR PRINTED WIRING BOARDS COMMON NOTE FOR PRINTED WIRING BOARDS MOUNTED PARTS LOCATION CIRCUIT BOARDS LOCATION...
Page 26
DSC-P41/P43 4-3. PRINTED WIRING BOARDS 4-3. PRINTED WIRING BOARDS 4-3. PRINTED WIRING BOARDS THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS • : Uses unleaded solder. • Chip parts. Transistor Diode • : Circuit board : Flexible board Pattern from the side which enables seeing. : pattern of the rear side (The other layers’...
Page 27
DSC-P41/P43 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS 4-3. PRINTED WIRING BOARDS 4-3. PRINTED WIRING BOARDS MOUNTED PARTS LOCATION MOUNTED PARTS LOCATION CD-501 Note for Printed Wiring Board (See page 4-35). : Uses unleaded solder. CD-501 BOARD (SIDE A) CD-501 BOARD (SIDE B) D803 SELF TIMER/ D803...
Page 28
Printed wiring boards of the CH-146 and SY-101 boards are not shown. Pages from 4-39 to 4-42 are not shown.
Page 29
DSC-P41/P43 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS 4-3. PRINTED WIRING BOARDS 4-3. PRINTED WIRING BOARDS MOUNTED PARTS LOCATION MOUNTED PARTS LOCATION SW-420 Note for Printed Wiring Board (See page 4-35). : Uses unleaded solder. SW-420 BOARD (SIDE A) SW-420 BOARD (SIDE B) S261 VIEW STILL...
Page 30
DSC-P41/P43 4-2. SCHEMATIC DIAGRAMS 4-2. SCHEMATIC DIAGRAMS 4-3. PRINTED WIRING BOARDS 4-3. PRINTED WIRING BOARDS MOUNTED PARTS LOCATION MOUNTED PARTS LOCATION ST-098 Note for Printed Wiring Board (See page 4-35). : Uses unleaded solder. ST-098 BOARD (SIDE A) FLASH UNIT R854 LND851 LND852...
DSC-P41/P43 NOTE NOTE 5. REPAIR PARTS LIST NOTE: Characters A to Z of the electrical parts list indicate location of exploded views in which the desired part is shown. EXPLODED VIEWS EXPLODED VIEWS Link Link FRONT CABINET FRONT CABINET LENS BLOCK SECTION BT HOLDER BLOCK SECTION REAR CABINET BLOCK SECTION LENS BLOCK SECTION...
Page 36
DSC-P41/P43 5. REPAIR PARTS LIST 5. REPAIR PARTS LIST SECTION 5 REPAIR PARTS LIST NOTE: • -XX, -X mean standardized parts, so they may have some differences from When indicating parts by reference number, the original one. please include the board name. •...
Page 37
DSC-P41/P43 5. REPAIR PARTS LIST 5. REPAIR PARTS LIST 5-1. EXPLODED VIEWS 5-1-1. FRONT CABINET BLOCK SECTION ns: not supplied Rear cabinet block section (See page 5-5.) BT holder block section (See page 5-4.) Lens block section (See page 5-3.) M901 Ref.
Page 38
DSC-P41/P43 5. REPAIR PARTS LIST 5. REPAIR PARTS LIST 5-1-2. LENS BLOCK SECTION - 5 0 IC801 (Note 1, 2) (Note 1) IC801 is not included in CD-501 complete board. (Note 2) Be sure to read “Precuations for Replacement of CCD Imager”...
DSC-P41/P43 5. REPAIR PARTS LIST 5. REPAIR PARTS LIST 5-1-3. BT HOLDER BLOCK SECTION ns: not supplied - 1 0 - 0 9 C852 DSC-P43 (including CP900 (CH-146 board)) SP901 BT901 BT001 The components identified by Les composants identifiés par une mark 0 or dotted line with marque 0 sont critiques pour la mark 0 are critical for safety.
DSC-P41/P43 5. REPAIR PARTS LIST 5. REPAIR PARTS LIST 5-1-4. REAR CABINET BLOCK SECTION ns: not supplied - 4 2 LCD901 D901 The components identified by Les composants identifiés par une mark 0 or dotted line with marque 0 sont critiques pour la mark 0 are critical for safety.
Page 46
[Description of main button functions on toolbar of the Adobe Acrobat Reader Ver5.0 (for Windows)] Toolbar Printing a text Reversing the screens displayed once • To reverse the previous screens (operation) one by one, click 1. Click the Print button 2.