MSI P965 NEO-F - Motherboard - ATX User Manual page 50

M S-7235 M ainboard
SATA#1 Configuration
This item allows you to configurare IDE device mode.
[Compatible] If Compatible selected, Legacy IDE Channels will only use IRQ14
and IRQ15.
[Enhanced] If Enhanced selected, you could use the other IRQs (except
IRQ14 and IRQ15).
I/O Devices
Press <Enter> to enter the sub-menu:
Onboard Floppy Controller
Select [Enabled] if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you install add-on FDC or the system has
no floppy drive, select [Disabled] in this field.
COM Port 1 / 2
This item allows you to select Serial Port1 base addresses.
COM Port 2 Mode
This setting allows you to specify the operation mode for serial port 2.
[Normal]
[IrDA]
[ASKIR]
Parallel Port
There is a built-in parallel port on the on-board Super I/O chipset that provides
Standard, ECP, and EPP features.
Parallel Port M ode
[Normal]
[EPP]
[ECP]
[ECP + EPP]
To operate the onboard parallel port as Standard Parallel Port only, choose [Normal].
To operate the onboard parallel port in the EPP mode simultaneously, choose [EPP].
By choosing [ECP], the onboard parallel port will operate in ECP mode only. Choos-
ing [ECP + EPP] will allow the onboard parallel port to support both the ECP and EPP
modes simultaneously.
Parallel Port IRQ
This item allows you to set parallel port IRQ.
3-12
RS-232C Serial Port
IrDA-compliant Serial Infrared Port
Amplitude Shift Keyed Infrared Port
Standard Parallel Port
Enhanced Parallel Port
Extended Capability Port
Extended Capability Port + Enhanced Parallel Port