AEG FAVORIT 86050 VI User Instructions
  1. Manuals
  2. Brands
  3. AEG Manuals
  4. Dishwasher
  5. FAVORIT 86050 VI
  6. User instructions
AEG FAVORIT 86050 VI User Instructions

AEG FAVORIT 86050 VI User Instructions

Fully integrated dishwasher
Hide thumbs Also See for FAVORIT 86050 VI:
Table of Contents

Advertisement

Quick Links

See also: Instructions for Using
FAVORIT 86050 VI
Fully Integrated Dishwasher
User Instructions

Advertisement

Table of Contents
loading

Related Manuals for AEG FAVORIT 86050 VI

Summary of Contents for AEG FAVORIT 86050 VI

  • Page 1 FAVORIT 86050 VI Fully Integrated Dishwasher User Instructions...
  • Page 2 Dear customer, Please read these user instructions carefully. Please observe the safety instructions on the first few pages of these user instructions! Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance.

  • Page 3: Table Of Contents

    Switching Off the Dishwasher ........
  • Page 4 Connecting the Dishwasher ........

  • Page 5: Operating Instructions

    • Keep all packaging away from children. • Keep all detergents in a safe place out of children’s reach. • The water in your dishwasher is not suitable for drinking. If there are still remnants of detergent in the appliance, there is a risk of burns! •...

  • Page 6: Correct Use

    • Only use detergents specifically designed for use in domestic dish- washers. • Do not put any solvents in the dishwasher. There is a risk of an explo- sion! • The anti-flood system provides dependable protection against dam- age due to leaks.

  • Page 7: Disposal

    • The dishwasher's interior light is always switched on as long as the door of the appliance is open. To save energy you should therefore always close the door of the dishwasher after loading or removing dishes.

  • Page 8: Appliance Features, Display And Control Fields

    Operating Instructions Appliance Features, Display and Control Fields Top Spray Arm Rubber Seal for Con- necting the Water Feed to the Upper Spray Arm Spray Arms Water Hardness Switch Container for Salt Container for Rinse Aid Detergent Dispenser Display and Control Fields Filters Rating Plate...

  • Page 9: Display And Control Panels

    Display and Control Panels Function buttons Control panel The control panel consists of the ON/OFF button gramme buttons with LED displays. Function buttons: In addition to the stated wash programme the fol- lowing functions can also be set using these buttons: Function button 1 Function button 2 Function button 3...

  • Page 10: Prior To Using For The First Time

    3. Fill with Rinse Aid Adjusting the Water Softener To prevent the build up of scale on dishes and in the dishwasher, the dishes must be washed with soft, i.e. low lime content water. For this reason the dishwasher is fitted with a water softener in which tap water from a hardness of 4 °d (German degree) is softened with the aid...
  • Page 11 *factory setting Adjust the water softener to the hardness of the water in your area as stated in the table: 1. The dishwasher must be switched off. 2. Manual adjustment: Open the dishwasher door. 3. Remove the lower rack from the dishwasher.

  • Page 12: Filling With Salt For The Water Softener

    5. Clean any salt remnants on the container opening. 6. Turn the lid clockwise to the stop, otherwise dishwasher salt will leak into the wash water, this could lead to poor wash results. To avoid this run a rinse programme after filling the salt container with special salt.

  • Page 13: Rinse Aid

    Only use rinse aid specifically designed for domestic dishwashers. Never fill the rinse aid container with any other substance (e.g., vinegar con- centrate or dishwasher cleaning agent) as this would damage the appli- ance. Switching Rinse Aid Supply On and Off 1.

  • Page 14: Filling With Rinse Aid

    If you use separate detergent and rinse aid, fill up with rinse aid: – prior to using the dishwasher for the first time – when the indicator The rinse aid compartment is on the inside of the dishwasher door. 1. Open the door. 2. Press the rinse aid compartment release button with your finger.

  • Page 15: Adjusting Rinse Aid Dosing

    Switching the Acoustic Signal for the End of the Wash Programme On and Off In addition to the visual indication the dishwasher can be set to emit an audible signal at the end of a wash cycle. 1. The dishwasher must be switched off.

  • Page 16: In Daily Use

    – Dishes and items of cutlery must not lie inside one another, or cover each other are of limited suitability: • Only wash stoneware in the dishwasher if it is specifically marked as being dishwasher- safe by the manufacturer. • Glazed patterns may fade if machine washed frequently.

  • Page 17: Loading Cutlery

    – To avoid damage to glasses, they must not touch – Do not lay small objects (e.g. lids) in the cutlery rack Loading Cutlery Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be posi- tioned horizontally in the upper basket.
  • Page 18 3. For larger items of cutlery, e.g. a whisk, half of the top for the cutlery basket can be left off. On some models of dishwasher it is possible to open the cutlery basket. To ensure that the cutlery basket...

  • Page 19: Loading Pans, Frying Pans And Large Plates

    Load large and heavily soiled dishes in the lower rack. To ease the loading of large items at some dishwasher-models the two rows of prongs for the right-hand plate insert can be folded down: 1. Slightly lift the right plate insert.

  • Page 20: Loading Cups, Glasses And Coffee Services

    Operating Instructions Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items.

  • Page 21: Adjusting The Height Of The Upper Basket

    Adjusting the Height of the Upper Basket With upper basket raised With upper basket lowered The height of the basket can also be adjusted when it is loaded. Lowering the Upper Basket: 1. Pull the upper basket out completely. 2. Holding the upper basket at the rear right, lift it as far as it will go and then lower it vertically.

  • Page 22: Filling With Detergent

    Please observe the manufacturer's dosing and storage recommenda- tions as stated on the detergent packaging. The detergent compartment is on the inside of the dishwasher door. 1. If the lid is closed: press release button (1). The lid springs open.

  • Page 23: Concentrated Detergent

    Concentrated Detergent Based on their chemical composition, dishwasher detergents can be split into two basic types: – conventional, alkaline detergents with caustic components – low alkaline concentrated detergents with natural enzymes. The use of 50 °C wash programmes in conjunction with concentrated detergents reduces pollution and is good for your dishes;...

  • Page 24: Selecting The Wash Programme (Programme Table)

    In addition to the wash programmes given in the table there is the special programme Pre wash A. Using this programme you can give an initial wash to dishes that are to be stored in the dishwasher ready to be washed later. The special programme Pre wash water and less than 0.1 kWh of energy.

  • Page 25: Start The Wash Programme

    Start the Wash Programme 1. Open the door of the dishwasher. 2. Check that when the dishes and cutlery are loaded into the dishwasher the spray arms are free to rotate. 3. Open the tap fully. 4. Press the ON/OFF button. The indicator in the ON/OFF button illumi- nates.

  • Page 26: Interrupting The Wash Programme (Only In Emergencies)

    Hot steam may escape from the appliance when opening the door. Open the door carefully. 1. Open the door of the dishwasher. 2. Rectify the reason for opening the appliance. 3. Close the door. The selected programme will then continue.

  • Page 27: Load Sensing - Sensor Logic

    • Hot dishes can be sensitive to knocks. The dishes should therefore be allowed to cool down before removing them from the appliance. • Leave the dishes in the dishwasher for approx. 15 minutes after the end of the programme so that they dry better and can cool down.

  • Page 28: Care And Cleaning

    Dirty filters will give poor wash results. 1. Open the door, remove the lower rack. 2. The dishwasher filter system com- prises a coarse/fine filter, microfilter and a flat filter. Unlock the filter sys- tem using the handle on the microfil- ter, and remove.

  • Page 29: What To Do, If

    What to do, if ... Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a of fault listed here, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee.

  • Page 30: Warning Tones Indicating A Fault In The Dishwasher

    ... Warning tones indicating a fault in the dishwasher. • If one or two repetitive warning tones can be heard after the start of a programme, they are indicative of a fault in the dishwasher that you can probably rectify yourself.

  • Page 31: There Are Problems With The Operation Of The Dishwasher

    – In the case of scale deposits on the dishes: the special salt container is empty or the water softener is incorrectly adjusted. Possible Cause The door of the dishwasher is not closed properly. Mains plug is not plugged in. Insert mains plug.

  • Page 32: Technical Data

    1-10 bar (=10-100 N/cm = 0.1-1.0 MPa) Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher door on the right. 850 x 600 x 600 (H x W x D in mm) 54 Kg 820 –...

  • Page 33: Notes For Test Institutes

    Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test programme (see Programme Table). Tests in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see Programme Table).

  • Page 34: Installation And Connection Instructions

    INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted to ensure that it is stable and level. • To compensate for unevenness in the floor and to match the height of the...

  • Page 35: Fitting The Furniture Door Panel

    Fitting the Furniture Door Panel (see installation template supplied) The door of the appliance can be fitted with a furniture door panel of the following dimensions: Width: 591 mm – 594 mm Thickness: 16 mm – 24 mm Height: max. 715 mm Weight: max.

  • Page 36: Connecting The Dishwasher

    • The dishwasher must be connected to a cold water supply. • The dishwasher must not be connected to open hot water appliances or instantaneous water heaters. Permitted water pressure...

  • Page 37: Water Inlet Hose With Safety Valve

    If the water inlet hose starts to leak during this operation, the safety valve cuts off the running water and the draining pump in the dishwasher is switched on. Please take care when installing the water inlet hose: –...

  • Page 38: Water Drain

    If the dishwasher is fitted at a high position If the dishwasher is installed at a high level, and the drainhose connec- tion is less than 30 cm from the bottom of the appliance, adapter kit ET 111099520 must be fitted.

  • Page 39: Leak Prevention System

    Installation and Connection Instructions Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the event of a fault, the safety valve immediately interrupts the sup- ply of water to the appliance and the drain pump switches on.

  • Page 40: Electrical Connection

    Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

  • Page 41: Connections

    Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installation example given below can only be regarded as a recommendation.

  • Page 42: Guarantee Conditions

    Guarantee Conditions GUARANTEE CONDITIONS Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar doc- umentation.

  • Page 43: Service And Spare Parts

    SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if you wish to pur- chase spare parts, please contact Service Force by telephoning: 08705 929 929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area.
  • Page 44 AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG 822 946 343 - 01 - 0602 Subject to change without notice...

Table of Contents