[Network Settings] - Sony BDV-E2100 Operating Instructions Manual

x [System Information]
You can display the system's software
version information and the MAC address.
x [Software License Information]
You can display the Software License
Information.

[Network Settings]

x [Internet Settings]
Connect the system to the network
beforehand. For details, see "Step 3:
Preparing for Network Connection"
(page 21).
[Wired Setup]: Select this when you
connect to a broadband router using a LAN
cable.
[Wireless Setup(built-in)]: Select this when
you use the built-in wireless LAN of the
system for wireless network connection.
Tip
For further details, visit the following website and
check the FAQ:
http://www.sony.com/blurayhtsupport/
x [Network Connection Status]
Displays the current network connection
status.
x [Network Connection
Diagnostics]
You can run the network diagnostic to
check if the network connection has been
made properly.
x [Connection Server Settings]
Sets whether or not to display the
connected DLNA server.
x [Renderer Options]
[Auto Access Permission]: Sets whether or
not to allow automatic access from a newly
detected DLNA controller.
[Smart Select]: Allows a Sony DLNA
controller to find the system as the target
equipment to operate by using the infrared
ray. You can set this function to on or off.
[Renderer Name]: Displays the system's
name as it is listed on other DLNA devices
on the network.
x [Renderer Access Control]
Sets whether or not to accept commands
from DLNA controllers.
x [PARTY Auto Start]
[On]: Starts a PARTY or joins an existing
PARTY at the request of a networked
device compatible with the PARTY
STREAMING function.
[Off]: Off.
x [Registered Remote Devices]
Displays a list of your registered remote
devices.
Note
To use this function, be sure to perform the
software update (page 46).
x [Remote Start]
[On]: Allows turn on the system by a
device linked via network when the system
is in standby mode.
[Off]: The system cannot be turned on by a
device linked via network.
US
51