Adjusting The Presser Foot Pressure; Adjusting The Trailing Length After Thread Trimming - Brother S-7200B Instruction Manual

Single needle direct drive straight lock stitcher with thread trimmer
Hide thumbs Also See for S-7200B:
Table of Contents

Advertisement

10-2. Adjusting the presser foot pressure

Correct stitches
Becomes weaker

10-3. Adjusting the trailing length after thread trimming

3676M
Upper thread
0894M
Skipped stitches occur
0895M
Uneven stitch length
0896M
Stitches are puckered
0897M
Becomes stronger
3674M
3675M
Shorter
Longer
The presser foot pressure should be as weak as possible,
but strong enough so that the material does not slip.
1. Loosen the adjusting nut (1).
2. Turn the presser adjusting screw (2) to adjust the presser
foot pressure.
3. Tighten the adjusting nut (1).
At the time of thread trimming, the thread tension is
loosened and tension is applied by the pretension (1) only.
The standard trailing length for the upper thread is 35-40
mm.
If the tension of the pretension (1) is increased, the
lengths of the threads trailing from the needle tips will be
reduced; if the tension is reduced, the lengths will be
increased.
Adjust by turning the pretension (1).
S-7200B
10. THREAD TENSION
Increase the pressure.
Decrease the pressure.
38

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents