Brother S-7200B Service Manual page 77

Single needle direct drive straight lock stitcher with thread trimmer
Hide thumbs Also See for S-7200B:
Table of Contents

Advertisement

Error code
Is the machine connector inside the control
Err
5
box disconnected?
(Safety switch
operated)
Is
Err
6
Was the power turned on while the treadle was still depressed?
(Voltage drop)
Is the power supply voltage too low?
Err
7
This is displayed when there is a problem communicating with the operation panel
CPU.
(Panel
Is the operation panel connector inside the control box disconnected?
communication
error)
Problem with operation panel or control box.
This appears on the display when the sewing machine has been operating
Err
8
continuously for 3 minutes or more.
(Over time)
Err
9
This is displayed when the motor becomes abnormally hot and the temperature
protection has activated.
(Motor
overheating
abnormally)
Problem with motor.
This is displayed when there is overcurrent in any of the solenoids (thread trimming,
Err
10
thread wiping, quick reverse or presser lifter).
(Solenoid
overcurrent)
Problem with control P.C. board.
Is connector CN5 inside the motor disconnected?
Err
11
(Problem with
motor over-
heating sensor)
Insert the connector securely.
the
machine head tilted back?
Return the machine head to its normal position.
Check the operation of the safety switch.
Return the treadle to the neutral position, and then turn on the power switch.
Check the power supply voltage.
Insert the connector securely.
Replace the operation panel or control box.
Turn the power switch off and then back on again, and then operate the
sewing machine normally.
After the temperature has dropped, turn the power switch back on and operate
the sewing machine as normal.
Replace the motor.
Check the resistances of the solenoids.
Replace the control box.
Insert the connector securely.
Possible cause
S-7200B
13. TROUBLESHOOTING
Page
52
25
3157M
54
52
49
3154M
39
55
49
3116M
70

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Md-741bMd-751bMd-741cMd-751c

Table of Contents