Adjustments; Adjusting The Actuator Position - Brother S-7200B Service Manual

6. ADJUSTMENTS

Maintenance and inspection of the sewing machine
should only be carried out by a qualified technician.
Ask your Brother dealer or a qualified electrician to
carry out any maintenance and inspection of the
electrical system.
If any safety devices have been removed, be
absolutely sure to re-install them to their original
positions and check that they operate correctly
before using the machine.
Use both hands to hold the machine head when
tilting it back or returning it to its original position. If
only one hand is used, the weight of the machine
head may cause your hand to slip, and your hand
may get caught.

6-1. Adjusting the actuator position

CAUTION
The installation position for the actuator (1) can be adjusted
to <A> or <B>.
Adjust so that it is in a position where it is easy to operate.
1. Remove the two screws (2).
Back
2. Move the switch setting base (3) to move the actuator (1)
to the preferred position <A> or <B>.
3. Tighten the two screws (2).
3687M
3688M
S-7200B
Turn off the power switch and disconnect the power
cord from the wall outlet at the following times,
otherwise the machine may operate if the treadle is
depressed by mistake, which could result in injury.
・ When carrying out inspection, adjustment and
maintenance
・ When replacing consumable parts such as the
rotary hook and knife
If the power switch needs to be left on when carrying
out some adjustment, be extremely careful to
observe all safety precautions.
6. ADJUSTMENTS
24