Brother S-7200B Service Manual page 14

3. FUNCTION SETTINGS (OPERATION PANEL)
Function No. 16 − 28
No. Initial value
16 3 (minutes)
17 0
18 20 (ms)
19 50 (ms)
20 50 (ms)
21 0
22 0
23
0 (stitches)
(NOTE 4)
24
0 (stitches)
(NOTE 5)
25
0 (stitches)
(NOTE 6)
26 0
27 0
28 0
(NOTE 3) The setting to the left of the " / " symbol is when the correction stitch icon is off, and the setting to the right is when
the correction stitch icon is on.
Turn the power off and back on again when this setting is changed. The setting will be enabled after the power
turns back on.
(NOTE 4) Stitch number setting is enabled when Function No. 118 is set from "1" to "3".
(NOTE 5) Stitch number setting is enabled when Function No. 118 is set to "2" or "3".
(NOTE 6) Stitch number setting is enabled when Function No. 118 is set to "3".
(NOTE 7) Operates when treadle is lightly pressed when Function No. 31 is set to "0".
7
Setting range
Overtime function
0 – 30 0: Not used
(minutes) 1–30: Machine stops after continuous operation for set time, and "Err 8" is
displayed.
Correction sewing function (See NOTE 3)
0: Half stitch correction sewing/Single stitch correction sewing
0 – 2 1: No correction sewing/Single stitch correction sewing
2: Reverse stitch (reverse feed) correction sewing/Single stitch correction
sewing
Thread wiping and presser foot lift operation timing after thread trimming
10 – 200 (ms)
10 – 200 (ms)
Thread wiping
10 – 200 (ms) Presser foot
lifting
Start backtack sewing operation
0 – 1
0: Stitch number A, B (N stop)
1: Stitch number A, B, A, B (N stop double)
End backtack sewing operation
0 – 1 0: Stitch number C, D
1: Stitch number C, D, C, D (N stop double)
0 – 99
Stitch number G
(stitches)
0 – 99
Stitch number H
(stitches)
0 – 99
Stitch number I
(stitches)
Speed for moving to end backtack
0: Decelerates to low speed, then end backtacking starts
0 – 1
1: Decelerates to end backtacking speed, then end backtacking starts
(Cycle time can be shortened.)
Continuous backtacking operation
0 – 1 0: Stitch number A, B, C, D
1: Stitch number A, B x D times
Feed direction when stopping immediately after start backtacking
0: Quick reverse solenoid turns off and stops in
normal feed direction
0 – 1
1: After stopping, quick reverse solenoid turns OFF
(See NOTE 7)
Setting details
Motor
Needle up stop
S-7200B
2245M
(fully ON)
2246M