Storing Channels In Memory (Optional) - Toshiba 39L4300UM User Manual

Integrated high definition led television
Hide thumbs Also See for 39L4300UM:
Table of Contents

Advertisement

66
Setting up your TV

Storing channels in memory (optional)

3
Press the p / q (arrow) buttons to select Antenna or Cable.
4
Press the OK button.
5
Select Start Scan.
After scanning is complete, the auto tuning results screen will
appear.
6
Press the OK or EXIT button.
Storing channels in memory (optional)
To make sure your TV stops only on the channels you want when you press
the CH p / q buttons on the remote control or the control panel, store
those channels in the TV's memory.
Auto Tuning
NOTE
You can set up the TV to detect all active channels in your area and store
them in its memory. Then you can manually store or skip individual
channels from memory.
Option:
Cable
Antenna
NOTE
1
Press the SETUP button.
2
Select Installation > Channel Tuning > Auto Tuning, and then
press the OK button.
A confirmation screen appears.
3
Press the OK button to start Auto Tuning or press EXIT button to
abort.
The TV cycles through the channels and stores all active channels
in memory.
You must set up the antenna/cable input source first. See
page
52.
Description:
Note: If you select Cable, auto tuning deletes previously stored channels
from memory.
This setup requires some time, but you do not need to repeat the setup
unless your cable TV service's lineup changes significantly.
To skip an antenna source channel and remove it from memory, set the
channel to be skipped. See
To tune to channels not stored in memory, use buttons 0–9 and the DASH
button on the remote control.
"Skipping channels" on page
"Initial setup" on
67.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents