Connecting The Processor Fan Heatsink Cable; Removing A Processor; Installing And Removing Memory; Connecting The Processor Fan Heatsink Cable To The Processor Fan Header - Intel D845GLVA Product Manual

Connecting the Processor Fan Heatsink Cable

Connect the processor fan heatsink cable to the processor fan header (see Figure 6).
Figure 6. Connecting the Processor Fan Heatsink Cable to the Processor Fan Header

Removing a Processor

For instruction on how to remove the processor fan heatsink, refer to the Intel World Wide Web
site at:
http://support.intel.com/support/processors/pentium4/intnotes478.htm

Installing and Removing Memory

CAUTION
To be fully compliant with all applicable Intel SDRAM memory specifications, the board requires
DIMMs that support the Serial Presence Detect (SPD) data structure. You can access the PC
Serial Presence Detect Specification at:
http://www.intel.com/technology/memory/pcsdram/spec/
✏
NOTE
Remove the card in PCI bus add-in card connector 1 before installing or upgrading memory to
avoid interference with the memory retention mechanism.
The desktop board has two DIMM sockets arranged as banks 0 and 1, as shown in Figure 7. If
installing a single DIMM, install it in bank 0.
Refer to the Main Memory heading on page 11 for memory requirements.
Installing and Replacing Desktop Board Components
OM15862
23