Network - Philips 50PFL3908/F7 User Manual

Network

Set up network connection settings in order to use Net TV or network
upgrade function.
• The meanings of abbreviations are defined as below.
AP: Wireless LAN Access Point
WPS: Wi-Fi protected Setup
SSID: Wireless network name
• The key entry screen will appear when you select SSID, WEP /
WPA / WPA2 or Proxy address.
1 2 3 4 5
a b c d e
k l m n o
u v w x y
Clear All clear
• Enter the key of the selected wireless network using ▲▼◄►,
then press OK.
Clear: Clear the entered number or word.
All clear:
Clear all the entered numbers or words.
a/A/@: Switch between abc, ABC and @!?
Cancel: Shows the cancellation display.
OK: Set the entered number or word.
1
Use ▲▼ to select Network, then press OK.
Settings assistant
Language
Channels
Picture
Preferences
Sound
Features
Network
Installation
Restore default settings
Software
Network settings assistant
Before you proceed to Connection test or other settings in Network section,
run the Network settings assistant to connect the TV to your network.
2
Use ▲▼ to select Network settings assistant, then press OK.
Language Network settings assistant
Manual network settings
Channels
Connection test
Preferences
Network Setting status
Restore default settings Home network
Reset network settings
3
Press OK to select Start now.
6 7 8 9 0
f g h i j
p q r s t
z . - _
a/A/@ Cancel OK
English
Autoprogram
Location
Network settings a
Reset AV settings
Start now
Network selection
Start now
Information
Renderer
Start now
Wireless setting
Select to use a wireless LAN to connect to the Internet by wireless
connection.
4
Use ▲▼ to select Wireless, then press OK.
This TV can be connected to your
home network.
Select your connection type.
If not connected to the network,
the latest TV software can be
downloaded from
www.philips.com/support
Cancel
5
Use ▲▼ to select the desired setting, then press OK, and follow
the on-screen directions.
Select this setting if your router has a WPS button.
Start scanning for wireless networks on the TV after
pressing the WPS button on your router. If
Easy connect
connection test fails, try Easy connect again.*
If it fails then refer to the router's manual for more
details.
Search for wireless networks automatically and
Scan
select the SSID from the list. Wireless network
setting ➟ p.38
Set up the connection to the AP (e.g. wireless
Manual
router) manually by entering the SSID.
*1 WPS (Easy Connect) cannot be used when the security protocol is set to
WEP. Change the Access Point's security mode from WEP to WPA or WPA2
(recommended).
Wired setting
Select to use an Ethernet cable to connect to the Internet by wired
connection. Please purchase shielded Ethernet cables at your local store
and use it when you connect to network equipment.
4
Use ▲▼ to select Wired, then press OK.
• Connection test will start automatically. ➟ p.39
Manual network settings
2
Use ▲▼ to select Manual network settings, then press OK.
Network settings assistant Network selection
Manual network settings Wireless network setting
Connection test IP configuration
Setting status Proxy configuration
Home network
Reset network settings
Network selection
3
Use ▲▼ to select Network selection, then press OK.
4
Use ▲▼ to select the desired setting, then press OK.
If you connect to an Ethernet cable, select Wired
Wired
to connect to the Internet.
If you have a router with WPS function, select
Wireless
Wireless to connect to the Internet.
37
English
Wireless
Wired
1
Wireless
Auto
IP setting mode
Proxy setting
Continued on next page.