Raid Configuration; Before Creating A Raid Set - Asus P5K-V - Motherboard - ATX User Manual

User manual
Hide thumbs Also See for P5K-V - Motherboard - ATX:
Table of Contents

Advertisement

5.4.2
JMicron
The JMicron
®
Serial ATA controller allows you to configure RAID 0, RAID 1 and
JBOD sets on the external Serial ATA hard disk drives.

Before creating a RAID set

Prepare the following items:
1.
Two SATA HDDs, preferably with the same model and capacity.
2.
A write-enabled floppy disk for Windows
Windows
®
Vista.
3.
Microsoft
Windows
®
4.
Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1.
Install an internal Serial ATA hard disk drive and an external Serial ATA hard
disk drive on your system.
Install the internal Serial ATA hard disk drive to the SATA connector labeled
SATA_E2.
Set the J-Micron eSATA/PATA Controller Mode item in the BIOS to [RAID].
2.
See section "4.4.5 Onboard Devices Configuration" for details.
Advanced
Onboard Device Configuraiton
High Definition Audio
Front Panel Type
Onboard 1394 Controller
Onboard PCIE GbE LAN
LAN Option ROM
J-Micron eSATA/PATA Controller
Controller Mode
Serial Port1 Address
v02.58 (C)Copyright 1985-2007, American Megatrends, Inc.
3.
Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4.
Create a JMB363 RAID driver disk for Windows
"5.5 Creating a RAID driver disk" for details.
5.
Install the JMB363 driver after the Windows
ASUS P5K-V

RAID Configuration

®
OS installation disk (Windows
®
BIOS SETUP UTILITY
[Enabled]
[HD Audio]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
[IDE]
[3F8/IRQ4]
XP or a floppy disk/USB device for
®
XP/Vista)
®
Enable or Disable
High Definition Audio
Controller
+-
F1
F10
ESC
OS installation. See section
®
OS had been installed.
®
Select Screen
Select Item
Change Option
General Help
Save and Exit
Exit
5-29

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

P5k

Table of Contents