Map Input Trays Menu Options - Lexmark T656 User Manual

3.5 MAP INPUT TRAYS Menu Options

This option defines the mapping of the host's request for a physical feeder or input tray in the printer. Any
host input source can be mapped to any printer input source. The printer input source is mapped to an
IPDS host number. Input sources include the multi-purpose feeder, envelope feeder, manual paper feed,
and manual envelope feed.
Some models may not support all printer input sources listed below. The optional sources will only be
displayed when installed on the printer. The Tray x Hp values are only displayed when the an optional
finisher that supports hole punching is installed. Pages can be hole punched using the "Tray x Hp" value
settings. See Hole Punching on page 61 for additional information.
You can configure up to 10 mappings. Select a Tray Mapping x in the MAP INPUT TRAYS menu
group (the value x represents any given Tray Mapping number). This displays a list of Tray Values which
identify the available printer input sources. When you select a Tray Value, the operator panel displays a
numerical setting screen to set the IPDS tray selection number that will select that printer input source.
Tray Mapping 1 through
Tray Mapping 10
Tray Value
IPDS Tray Selection
Number Values
A typical relationship between IPDS Numbers and input sources would be
Tray Map. No.
Tray Mapping 1
Tray Mapping 2
Tray Mapping 3
Tray Mapping 4
Tray Mapping 5
Tray Mapping 6
Tray Mapping 7
Tray Mapping 8
Tray Mapping 9
Tray Mapping 10
Note: The labels Tray Mapping 1 - Tray Mapping 10 refer to the number of the mapping, not the
physical tray.
34
Tray Mapping x is a sub-menu selection item. Each item refers to the
number of the mapping, not to the physical printer tray.
Tray Values specify the physical printer tray. The tray values specified
below are available under the specified printer's Tray Mapping sub-
menu when the physical tray is installed and available.
Check your printer documentation for information on optional tray and
feeder support. Values that may be displayed when trays on feeders are
installed are shown below.
Tray 1, Tray 1 Hp, Tray 2, Tray 2 Hp, Tray 3, Tray 3 Hp, Tray 4, Tray 4
Hp, Tray 5, Tray 5 Hp, MP Feeder, Env Feeder, Manual Paper, Manual
Paper Hp, Manual Env, No Map
The value range for the IPDS Tray Selection Number is 0 to 255. If an
IPDS tray selection number is mapped (used) twice, the lowest tray
mapping (if available) is used.
Input Source Value
Tray 1
Tray 2
Tray 3
Tray 4
Tray 5
Envelopes (Feeder)
Envelopes (Manual)
Manual Paper
MP Feeder
No Map
IPDS (Tray Selection) Number
0
1
2
3
4
64 (40H)
64 (40H)
99 (63H)
98 (62H)
---