Two-Dimensional Bar Codes; Bar Code Descriptor For Codablock F - Lexmark T656 Technical Reference Manual

Two-dimensional bar codes

Bar code descriptor for Codablock F

Field Name Type
Esc (s#T name
Esc Int
(s#1,#2,[#3]V
Int
Int
Esc (s#1]B Int
HP BarDIMM Deviations:
The HP BarDIMM Pro uses the PCL5 Height command "V1" to specify the single line bar Height of
the Codablock F bar code, IE: the height of one of the rows contained in the bar code. No provision is
made to specify the absolute height of the Codablock F symbol. Parameters V2 and V3 are derived
from the ELMICRON Specification.
The HP BarDIMM Pro specification specifies that the Codablock V parameter #1 is the "single line
bar height in 1/60". But that is incorrect—it is actually in 1/72".
Range
na
Min: 3 (dec) or
03 (hex)
Max: No maximum
Min: 2 rows
Max: 44 rows
Min: 4 columns
Max: 103 columns
Min:
Min. value of B1 is 1, but
may be an unreadable
symbol.
Max:
There is no max value
for B1, but larger
barcodes may use up
too much memory.
Two-dimensional bar codes
25
Default
(if not specified)
n/a
16 (dec)
or
10 (hex)
2 (dec)
or
02 (hex)
20 (dec)
or
14 (hex)
6 (dec)
or
06 (hex)
Description
Required.
24840T
Optional.
Selects bar height.
Bar height in 1/72",
same units as fonts.
Note: Values from 0 to 2
are the same as the
default.
Optional for Forms and
Bar Code Card,
required for HP
BarDIMM. (See
"Deviations" chapter of
this Technical
Reference.)
Requested number of
rows in the Codablock F
symbol.
Optional.
Requested number of
columns in the
Codablock F symbol.
Optional.
Selects bar width.