Replacing The Existing Control Unit With The Disklavier Control Unit - Yamaha disklavier DKC-850 Operation Manual

Chapter
2
Getting Started

Replacing the Existing Control Unit with the Disklavier Control Unit

Connect the Disklavier control unit to your piano, replacing with the existing control unit.
5
Conversion
cable
(supplied)
4
Cautions
• Use the Yamaha PJP-PS02/PJP-PS04 adaptor, or an equivalent recommended by Yamaha. Use of
other AC adaptors may result in damage, overheating, or fire.
• Do not stretch the cable or bend its ends.
• Do not attempt to use the cable if it is stretched or if the ends of the cable have been bent. Attempting
to do so may cause interruptions to the power supply.
• Always turn off the main unit power before disconnecting the AC adaptor.
• When you wish to move the Disklavier control unit, unplug the AC adaptor from the AC wall outlet
and disconnect if from the DC-IN 12V connector on the rear panel of the Disklavier control unit before
proceeding.
• Unplug the AC adaptor from the AC wall outlet if you do not intend to use the instrument for an
extended period of time.
8
7
Tighten
Disklavier
control unit
6
Connect monitor
speakers.
See page 12.
Control
cable
3
Tighten
AC adaptor (PJP-PS02/PJP-PS04)
(supplied)
Your piano
Loosen
8
Power cable
(supplied)
9