Editing An Existing Route On-Screen - Raytheon RayChart 620 Operation Manual

26

Editing an Existing Route On-Screen

You can edit the current route, even if it is active. You do this using the
same screen you used for entering a new on-screen route.
To add waypoints to the end of an existing route:
1. Press the ROUTE soft key to display the Route menu and the
2. If required, press the SELECT soft key to select a different route.
3. Use the trackpad, or press the ROUTE soft key, to highlight the
You can now add, delete or insert waypoints, although you cannot
delete a waypoint if you are tracking towards it.
Note: You can also use this option to delete waypoints that are not part
of the current route, if you have selected the waypoint display option
when you set up your RayChart (see Chapter 6).
To delete a waypoint:
1. Use the trackpad to position the cursor over the waypoint you wish
2. Press the DELETE WPT soft key.
3. Press ENTER to confirm the deletion, if the waypoint is used in a
To insert an additional waypoint in a route:
1. Position the cursor on (or close to) the line between two existing
current route selection.
The Route menu shows the complete list of options when a route is
present, and the route is displayed on the chart if it is in the currently
displayed area.
MAKE/EDIT option, and press ENTER.
The cursor is connected to the last-placed waypoint with a dotted
line, ready to add further waypoints to the route in the same way as
for a new route.
to delete, until the data for that waypoint is displayed in the object
data box.
route.
The waypoint disappears from the screen. If the waypoint was not
at the end of the route, then the waypoints before and after the
deleted waypoint are connected with a straight line.
waypoints.
RayChart 620