Replacing The Air Filters - Epson EMP-7950 User Manual

Maintenance
Select "Reset Lamp Timer" from the "About" menu
2
and then press the [Enter] button on the remote
control or the [Auto/Enter] button on the projector's
control panel.
:
Lamp (High Brightness)
:
(Low Brightness)
:
Reset Lamp Timer Execute
:
Source Computer
:
Input Signal Auto
:
Frequency H ---.--kHz
:
V ---.--Hz
:
SYNC Polarity H ------
: V ------
SYNC Mode : ------
:
Resolution 0x 0
:
Refresh Rate 0.0 Hz
Select "Yes" and then press the [Enter] button on the
3
remote control or the [Auto/Enter] button on the
projector's control panel.
The lamp operating time will then be reset.
Reset Lamp Timer Reset Lamp Timer
Execute? Execute?
YES YES
0H
0H
NO NO

Replacing the Air Filters

If the air filters are broken or if the warning message reappears after they
have been cleaned, they should be replaced.
The air filter can be replaced even if the projector is installed on a ceiling.
PROCEDURE
Turn the projector's power off, wait for the
1
downgperiod to end, and then disconnect the power
cable.
The cool-down period lasts for about 20 seconds.
User's Guide
146
cool-