Epson EMP-7950 User Manual page 131

Problem Solving
You cannot connect from another computer when images are being projected during a network connection (EMP-7950 only)
Check
Has the person making the presentation left
the meeting room without closing the
connection?
EMP NS Connection starts, but a projector is not found (EMP-7950 only)
Check
Is the wireless or wired LAN card inserted?
For the EMP-7950
Is the network cable connected correctly?
When using the EMP-7950
connected to a wired LAN, or
when using the EMP-7900
Is the access lamp of the wireless LAN card
that is inserted into the projector lit green?
Is the projector displaying the EasyMP
configuration menu screen?
Is the computer ready for LAN card or in-built
LAN functionality to be used?
If you try to connect to a projector from a computer while Network Screen is running and the
projector is already connected to another computer, the connection to the first computer will be
terminated and the projector will then connect to the next computer.
If no projector keyword has been set in the projector or the keyword is known, it is possible to
terminate the current connection and connect to the projector by establishing a new connection from
the computer.
If a projector keyword has been set in the projector and the projector keyword is unknown, terminate
the connection from the projector and then reconnect. To terminate the connection from the
projector, press the [ESC] button on the remote control, select the "Exit" button from the displayed
menu and then press the [Enter] button on the remote control. Connect from the desired computer
after terminating the connection.
"Disconnecting from a Network Connection" in the EasyMP Network Setup Guide
Check that the wireless LAN card is correctly inserted into the card slot of the projector.
"Inserting and Removing Cards"
Check that the network cable is connected correctly. If it is not connected or is connected
incorrectly, reconnect it.
If the access lamp is off, remove the wireless LAN card and re-insert it.
"Inserting and Removing Cards"
Network connections are disabled while the EasyMP configuration setting screen is displayed.
Close the configuration settings to return to the EasyMP standby window.
Check whether the LAN device is functioning in the Device Manager. For example, "Control panel" -
"System" - "Device Manager".
Remedy
Remedy
p.17
p.17
User's Guide
130