Problems Relating To Networks And Easymp - Epson EMP-7950 User Manual

Problem Solving

Problems Relating to Networks and EasyMP

Mail notification messages are not being sent when a problem occurs with the projector
Check
Is the wireless or wired LAN card inserted?
For the EMP-7950
Is the network cable connected correctly?
When using the EMP-7950
connected to a wired LAN, or
when using the EMP-7900
Are the settings for connecting to a network
correct?
Has "Standby Mode" been set to "Network
ON"?
Has a critical problem developed causing the
projector to momentarily stop working?
Is power being supplied to the projector?
Check that the wireless LAN card is correctly inserted into the card slot of the projector.
"Inserting and Removing Cards"
Check that the network cable is connected correctly. If it is not connected or is connected
incorrectly, reconnect it.
Check the network settings for the projector.
If using the EMP-7950 "Connecting in Access Point Mode or Wired LAN Mode" in the EasyMP
Network Setup Guide
If using the EMP-7900 p.101
If using the mail notification function while the projector is in standby mode, change the "Standby
Mode" menu setting to "Network ON".
When the projector has momentarily stopped working, it cannot send e-mail messages. If the
projector cannot be reset even after it has been checked, contact your dealer or the nearest address
provided in the "International Warranty Conditions" section of the Safety Instructions/World-Wide
Warranty Terms booklet.
Check if the power supply to the location where the projector is set up has been interrupted, or if the
circuit breaker for the electrical outlet that the projector is connected to has been tripped.
Remedy
p.17
"Advanced1" - "Standby Mode"
User's Guide
128
p.91