Epson EMP-7950 User Manual page 126

Problem Solving
Image colours are not right
Check
Do the input signal settings match the signals
from the connected device?
Has the image brightness been adjusted
correctly?
Are the cables connected correctly?
Has the image contrastg
correctly?
Has the colour been adjusted correctly?
Has the Wall Shot function been set to "Wall
Shot ON"?
Have the colour intensity and tint been
adjusted correctly?
Only when projecting images
from a video source
If the "Comoputer Input" or "BNC Input" in the configuration menu has been set to "Component
video" when a computer or RGB video is connected to the [Computer] port or [BNC] ports of the
projector, the image will appear purplish.
If the "Comoputer Input" or "BNC Input" in the configuration menu has been set to "RGB" when a
component videog
will appear greenish.
Select the correct signal format for the connected source.
"Setting" - "Computer Input", "BNC Input"
If a composite videog
menu command to select the video signal format.
"Video" - "Video Signal"
Use the "Brightness" menu command to adjust the brightness.
"Video" - "Brightness"
Check that all of the cables required for projection are securely connected.
been adjusted Use the "Contrast" menu command to adjust the contrast.
"Video" - "Contrast"
Use the "Color Adjustment" menu command to adjust the colour.
"Advanced1" - "Color Adjustment"
When projecting onto a normal screen, press the [Wall Shot] button on either the remote control or
the projector's control panel to change the setting to "Wall Shot OFF". To re-adjust the Wall Shot
setting, use "Wall Shot Readjustment".
Use the "Color" and "Tint" menu commands to adjust the colour and tint.
"Video" - "Color", "Tint"
Remedy
is connected to the [Computer] port or [BNC] ports of the projector, the image
p.86
or S-Videog source is connected to the projector, use the "Video Signal"
p.82
p.78, p.81
p.78, p.81
p.90
p.52
p.81
User's Guide
125
p.21–p.28