Edelbrock Acura Integra 6737 Installation Instructions

Please study these instructions carefully before installing your new Pro-
system. Failure to follow these instructions may void your warranty. If you h
Monday through Friday, Pacific Standard Time.
e Acura 1.8L (Non-VTec) engine. A performance gain can be expected with the
installation of the system. This system requires no welding for installation and retains all stock
emissions equipment.
Suggested tools needed for installation:
3/8" ratchet socket set with extensions and a good assortment of metric sockets
Combination wrenches (metric)
Universal 12mm and 14mm swivel sockets
Jackstands, screwdrivers, pliers, crescent wrench, etc.
Liquid penetrant (GM #1052627 or equivalent); anti-seize compound (GM #5613695 or
equivalent)
SPECIAL NOTICE:
the California Air Resources Board (C.A.R.B.) making it legal for street use on pollution-con
motor vehicles in all 50 states. To assist you with emissions equipment certification, we have
replacement part on the vehicle for which it is cataloged.
affixed to your fan shroud next to the existing emission and engine specification decal.
cover your original equipment specification decal with the Edelbrock fan shroud decal.
The use of "Thermal Wrap" or any aftermarket coating process will void the
warranty on your Pro-Flo header. Those products can cause excessive heat and moisture build up
resulting in corrosion and early failure of the system.
1. Disconnect battery negative cable from battery.
2. Raise vehicle and support with jackstand.
3. The use of penetrating oil when removing and the use of anti-seize compound when
installing nuts and bolts will prevent the possibility of broken or stri
4. Make sure converter is cool.
1994-2001 Acura Integra GS, RS, LS (Non-
-Flo header components are designed to improve the exhaust
This Edelbrock part has received an Executive Order number (E.O. #) from
roud decal to help testing personnel verify that this part is a legal
Catalog PNs 6637, 6737, 6837
died and understood before you remove your stock
-800-416-
has some metric fasteners.
Pro-Flo Header
–
-backed decal should be