Advertisement
Quick Links
PostScript Picture
(Edelbrock B/W Logo.eps)
PLEASE study these instructions carefully before installing your new fuel pressure regulator plate kit. If you have any
questions or problems, do not hesitate to call our Technical Hotline at: 800-416-8628, 7 am - 5 pm, Monday-Friday, Pacific
Standard Time or e-mail us at edelbrock@edelbrock.com.
FUEL PRESSURE REGULATOR PLATE KITS
Catalog # 8192:
Catalog # 8193:
Catalog # 8195:
1. Fuel inlet and outlet ports are marked on
regulator.
2. Fuel line has provision for fuel pressure
gauge (1/8" pipe).
3. Fuel inlet port accepts AN fitting supplied
for #8 fuel Line.
4. Fuel pressure is adjusted by loosening
5/8" lock-nut "A" on top of regulator and
with 7/32" Allen key, turn set screw "B"
to desired setting.
5. Re-tighten lock nut.
Caution:
Do not over-tighten fittings in
pressure regulator. Fittings which go with
pipe threads tend to crack parts when over-
tightened. Use a good pipe sealant to create
a
proper
seal.
(Pipe
recommended for this application).
must be taken when installing two self-
tapping 1/4-20 support bolts in regulator.
We suggest tapping threads prior to
installation, ("C").
Upon engine start-up,
check all fittings and hoses for possible fuel
leaks. Adjust pressure to desired settings.
Brochure #63-0059
© 2001 Edelbrock Corporation
FUEL PRESSURE REGULATOR PLATE KIT
Standard-flange dual-inlet Holley carburetors (gasoline only)
Pressure range 4-1/2 to 9 P.S.I. (preset to 7 P.S.I.)
4500 Series dual-inlet Holley carburetors (gasoline only)
Pressure range 4-1/2 to 9 P.S.I. (preset to 7 P.S.I.)
Standard-flange dual-inlet Holley carburetors with GM throttle cable bracket (gasoline only)
Pressure range 4-1/2 to 9 P.S.I. (preset to 7 P.S.I.)
tape
is
not
Care
INSTALLATION INSTRUCTIONS
#8192 Shown
Page 1
Catalog #8192
Catalog #8193
Catalog #8195
B
A
C
Rev. 12/01
Advertisement
