Advertisement
Quick Links
Please read both your DIRECT PORT INSTRUCTION MANUAL and this JET MAP insert before installing your Edelbrock Nitrous
System. If you have any questions or comments, please feel free to contact our Technical Hotline at: 1-800-416-8628 from 7a.m.-
5p.m., Monday through Friday, Pacific Time or e-mail us at Edelbrock@Edelbrock.com. Please fill out and mail your warranty card.
Qty. Description
❑ 2
❑ 2
❑ 8
❑ 8
❑ 8
❑ 8
Approx. HP Gain Nitrous Jet
The jet map shown above shows the approximate horsepower gain for each nitrous jet size (maintaining a bottle pressure of
approximately 925 psi), based on the correct timing retard and additional fuel required to flow through your injectors. The additional fuel
flow is crucial because if the additional fuel flow is not enough, you will experience a lean condition which could cause serious engine
damage. When tuning your system, you should start with a rich condition and slowly lean the nitrous tune-up out to the desired
performance level. Always remember, a slightly rich nitrous/fuel ratio will extend the life of the engine drastically, but only slightly reduce
the performance.
©2005 Edelbrock Corporation
Brochure #63-0358
Victor Pro Nitrous Solenoid
Distribution Block
Dry EFI Nozzle
3/16" Tubing
Tube Sleeve
Blue Tube Nut
250 HP
28
300 HP
32
Edelbrock Corporation • 2700 California St. • Torrance • CA 90503
Tech Line: 800-416-8628
E-Mail: Edelbrock@Edelbrock.com
SUPER VICTOR DRY EFI DIRECT PORT PLUMB KIT
BILL OF MATERIALS
Qty.
❑ 8
❑ 8
❑ 2
❑ 1
❑ 2
❑ 2
Jet Map
Sugg. Timing Retard
10°+
12°+
Office: 310-781-2222
INSTALLATION INSTRUCTIONS
Description
Nitrous Jet
Compression Fitting
Union Fitting
Blue 6AN Y-Fitting
6AN Filter Fitting
6AN 15in. Hose
Fuel Required (lb./hr.)
122-147
151-181
JET MAP
CATALOG #71810
Catalo #71810
Rev. 8/05 - DC/mc
Advertisement
