Kenwood DPX-4020 Instruction Manual page 37

Double din sized cd/cassette receiver
Hide thumbs Also See for DPX-4020:
Table of Contents

Advertisement

PROBLEM
A track will not play.
The DSP effects are
imperceptible.
Disc Control Mode
The disc control mode cannot
be selected.
The specified disc does not
play, but another one plays
instead.
The sound skips.
The display shows that the
changer is being played, but no
sound can be heard.
The specified track will not
play.
Track repeat, disc repeat, track
scan, disc scan, random play,
and magazine random play
start by themselves.
Cannot play CD-R or CD-RW
If the following situations, consult your nearest service center:
• Even though the disc changer is connected, the Disc Changer Mode is not on, with "AUX" showing in the display during the Changer Mode.
• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS89, KDC-CPS87, KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the AUX
Mode is entered when switching modes.
POSSIBLE CAUSE
Random play has been selected.
You are using a two-speaker system.
The front and rear output are reversed.
The + and - of speakers are reversed.
The fader or balance settings are set all the way to one
side.
No cable has been connected to the disc changer input
terminal on the unit.
The specified CD is quite dirty.
The CD is upside-down.
The disc is loaded in a different slot from that specified.
The disc is severely scratched.
Something is touching the disc changer.
The CD is scratched or dirty.
The computer chip in the unit is not functioning normally.
Random play or magazine random play has been
selected.
The setting is not cancelled.
Finalization processing is not being conducted for CD-
R/CD-RW.
A non-compatible CD changer is being used to play the
CD-R/CD-RW.
Turn off random play.
Use a front/rear four-speaker system.
Connect the wire correctly, referring to the section on
"Connecting Wires to Terminals".
Connect the wire correctly, referring to the section on
"Connecting Wires to Terminals".
Reset the fader or balance settings.
Connect the cable to the disc changer input terminal on the
unit.
Clean the CD.
Load the CD with the labeled side up.
Eject the disc magazine and check the number for the
specified disc.
Try another disc instead.
Remove whatever is touching it.
If skipping happens at the same place when the car is
stopped, something with the CD is wrong. Clean the CD.
Press the reset button on the unit (see p. 4).
Turn off random play or magazine random play.
The settings for these functions remain on until the
setting to off or the disc ejected, even if the power is
turned off or the source changed.
Conduct finalization processing with CD recorder.
Use a CD changer compatible with CD-R/CD-RW to play.
— 37 —
SOLUTION

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dpx-4020ph4Dpx-4020mh4Dpx-5030Dpx-5050

Table of Contents